Move lim turbo Punto 1.3 mjet 70 HP more than 1.5 bar

[Tinturia]

I knew that in order to increase the pressure of the turbo mechanically it istallava a tap T in the tube of the control of the wastegate valve to move more? in the high point of the opening of the valve itself, cos? to reduce the rpm of the impeller and get the pressures pi? high in the turbine.
Question: Inserting the emulator of the turbo pressure it is necessary to insert the T-piece? (I don't think, but me ? come to doubt)

[SandroMarciano]

what ? do not bring the error to the control unit (putting the module) what ? increase materially the pressure (with the connection to the "T")

[Tinturia]

so if I wanted to increase the pressure in the turbine should I put the T-piece but to do so that the unit does not go into error (why? maybe I have exceeded 1.5 bar) I have to put in the emulator. With only the emulator (by moving the restrictor to the turbo) then it does not increase the operating pressure of the turbine!?

[Fede78]

With the turbine original enough and advances the pressure of 1.5 before it goes into recovery.
Put the faucet and adjust the peak at 1.4 bar and not go? in recovery and you will have a constant pressure of about 1.2 bar

[Tinturia]

Ok! Thank you very much.

[leandro89]

honestly, I think I've found the pressure limiter turbo, I took as an example a file of a 500 75hp, in the driver you can find turbo pressure, as the maximum value we are at 205, which, when multiplied by the conversion factor of that? 14 at about 2800mbar

the limiter pressure turbo is located just before the 2 maps of turbo pressure, search for it in 2d 8bit, are a series of gobbette with maximum value 179, which, when multiplied by 14 is 2506mbar, i.e. the limit of the turbo pressure.

but the question springs to mind...those 2 maps in the drivers of the ecm are called pressure turbo, what kind of maps ARE?????
may not be pressure turbo

hello, the conversion factor 14 of which you speak ? a number that comes from some calculation is precise? if so, which one?
thanks a lot

[Alessandro sp]

sorry guys but can I know if someone managed to move the recovery of the turbo....xke no I can not and or tried to put the resistance, but the machine nn is completely and from the map I can .......the machine and a grande punto 1.3 75 hp 2009

[Danny]

You put the resistance in the wire wrong.
I know that you can? right from the map...But the only drawback of having the resistance ? the light turned on, anything about the other...sure the machine goes

[Alessandro sp]

from the sensor out of the three wires a, and the mass of that black there are 2 I took the one that takes the 5v output ...but the thing that is known, and as if canbiassero the pontifical council for culture dispensing pero nn or tried the second wire ..then to me the spy nn turn then and strange avro wrong thread pero talk that the pressure 1.8 bar, and I mounted a turbine largest

[Danny]

we talk about that I was a 1.9 with resistance on the map....The light will turn on xk? va disagreed with the pressure to a minimum, with respect to the p-atm.
Where are you from?!?