and one thing that I do, and I thank you for the advice, for the less c'? someone that already? the fact to give a straight.
these days are very busy but just find space to proceed? immediately.
Into the country from me, there are mappers that boast their ability? but I have never heard a vehicle mapped by them.
Thanks hello
hello I have 2 questions about ECM
1: ? possible if you select any part in 2D, to me this should also be seen in the HEX code or Ansi? If a driver ? was chosen and ? located in a map, but also goes to a parking lot?
2: ? in fact I use ir? common first builders different versions of the software in the controller. Every so often, to?, they have about the same maps, but in different places.
It is in any way possible if two files with the other with respect to postpone the areas so that the overlaid the maps, so you can directly compare?
I hope you understand ****** Italian, why? I can not find any English
Maybe ? you better write in English that you understand better!
discussion cleaned, by regulation, writes in ItalianOriginally Written by pitty
Maybe ? you better write in English that you understand better!
Sorry I didn't remember this thing here!
To answer! You can do this just select the two original maps and insert it as if it were modified.
After 2d, you can scroll through the maps like you always do and overlay to see the differences.
I know how to compare two files in the ECM, but in the case of two versions of the software diffrent the pi? sometimes the maps are on diffrent places ..
cos? when you chosse a driver and go to the map you see only nonsense in the other file, why? the map matching ? the place different.
So there must be the possibility? lay both of the maps that are common to each other.
Do you understand?
In this world you have to spend money if you want to learn something and if you don't know where to put hands trusted only do damage and then leave it alone alientech you are a slave to them and you will never be operating not to mention the money that you are asking for...the first thing already? that parts from a theoretical basis ? very important then, once you read the file you'll know how and where to go to change given that not all of the items that you will find will be changed...
* ake85
if this was a response to my question, I believe that you do not understand my question.
I know how to identify the maps, and I have the knowledge to modofy them.
My question was different.
My question was if ? can move the maps from left to right so you can put them one above the other, so you can compare the versions of the software diffrent
hello, I think I understood what you want to do, at the bottom there are 2 buttons "ori" and "mod" click on one of the 2, and with the arrows that you use usually move the map, you'll see that it moves only a map, when they are on top of the other, then click again on the button, so? they move together again, if you want to come back as in origin click on the 2 arrows (red and blue).
hello I hope I helped you
*sisco
I do not quite understand your explanation. I have now made a sketch, then I think it will be? wasier. Watch the sktech at the top you will see two "maps" one ? color blue (map), and one with the color red (map B)
Both of the maps, for example, are of the same typ of engine, but on diffrent places in the software.
Now I want to move the map so that it is exactly above the other in such a way that you can? see directly increases! (as shown in the photo below)
This ? possible with the ECM or not?
some programms hexagonal like UltraEdit (ultra compare) pu? make a similar solution, but only in hexadecimal.
I'm looking for a mapping tool that offers this functionality?. Supports ECM?
example.JPG
Write permission
Quote