start with the bdm with a marelli for who ? novice I do not think a simple thing.
first of all, once open you should desolder a resistor and then to read it in full...
However, we are of the forum we can help you if you want.
start with the bdm with a marelli for who ? novice I do not think a simple thing.
first of all, once open you should desolder a resistor and then to read it in full...
However, we are of the forum we can help you if you want.
I agree
Thank you all for the advice I do not know yet to read the ecu in bdm and I have not the suitable equipment are able to read with the cock, with the drive - Fiat - 1.3 mjt 16v iaw - 63F *can and the data control unit 51871687 - 3646pm94 - mjd6f3hw04p and I generated a file of 2048 kb.
hello beautiful then abandons everything to stop the cock before you do stupid things..... you have to take a simple mpps and to do everything with the cmq pay me to go back to the ori...and a stro......zz..... cmq registered well presented and not be in a hurry, otherwise you do stupid things.....especially cn rooster clone...
? the virtual file that corresponds to the original file of your controller, to read the changed you have to do to force bdm for? if you want to put gold you can write the files that will be generated
Hello guys, I'm in no hurry for this, I am writing to the forum and to understand, to put it back to the original ecu, should I bring the file that generated the one who modified it and rewrite it with the cock, otherwise I can't do anything.-
no you can use the file that gives you the rooster, ? identical to your original one, I'll explain, the marelli can be read in serial mode, the file that gives you the cock ? your original extrapolated from the internal database, if you write your car returns to the original 100%
who has mapped has done the same thing trusted ;-)
Last edited by leandro89; 14-08-2014 to 23:13
I see from what you tell me that ? a very charming, so follow? the board of poles and try? of the study a little before going to change thanks
mpps writes the file mode, but you have to cut it to 1mb, otherwise nothing to do.Originally Written by michell
Thanks polini, currently I only read the data in the ecu, I have not yet tried to rewrite it, but as said rodcraft86, I when I go to read with the rooster clone fgtech v54, I read the original file and not the one mapped ?.-
