After that I put the file you have prepared, I went out the written code, in fact, I wrote it here on the forum.
when it comes to the written part of the machine
After that I put the file you have prepared, I went out the written code, in fact, I wrote it here on the forum.
when it comes to the written part of the machine
And then the file is not good.
what can I do? which could be the cause? thanksOriginally Written by blackwolf76
the file you have prepared? not ? the first one I that's strange.
Last edited by leandro89; 12-08-2014 to 20:05
I the one solution I have used it several times and it worked...
I speak from ignorance as ? was carried out a mapping could be that the code of the ecu has been changed and cause problems?
they told me that I should also unsolder the cip for the partial, but I don't have the equipment....
that I could control other
thanks
If the mapping ? was made after that, it might be that the base does not ? the one on which I made the mod so that it might be lost. The part you need anything if you have problems with immo...
should I try the base through the codes written on the outside of the ecu in case ?
E-mail the current reading of the car, try it on that.
the file that I had posted was the current mapping, ok
not could you tell me something else why? it does not take the scodifica? thanks
Write permission
Quote