hello guys anyone knows how to compare two files ori with the ecm? see on the chart type, the difference between a 150 hp and 170 ?or acceleration between 165 and a 170cv?thanks to whoever can help me
hello guys anyone knows how to compare two files ori with the ecm? see on the chart type, the difference between a 150 hp and 170 ?or acceleration between 165 and a 170cv?thanks to whoever can help me
The last I see, for the fact that the two units are identical and it is impossible to find them.. even if the same means and the same control unit usually have changes in the software... but to make a comparison you can find in both maps that interest you and then block one of the two, and slide the other until the stack... simple but intuitive
instead, it's simple just take a 159 for the Italian market and a 159 for the foreign market..... Italian 150hp foreign 170 hp the same unit
what is meant by corland ? that once you are in the hand of the two files and compare them to find the differences concern not only the difference of mapping
if they have different powers will probably have versions of different software (even if the same hardware), so the comparison doesn't it ? cos? immediate
you must be able to distinguish between what depends on the software and what depends on different parameters management
of this car, I don't know, but, in my small experience, comparing gold to other cars with the same hw curves were gi? aligned
if it were not so? the only ? locate the area of your interest and try to align the two files
in fact, why? using the x button to see the increments do you give? all the other curves that have different bit
not ? said that they are different![]()