We can do I have to climb??? I already created both in the limiter torque that the continuous injection of the graph outside the driver
We can do I have to climb??? I already created both in the limiter torque that the continuous injection of the graph outside the driver
The map of the advances should be this (taken from the files of the point 69cv)
X: Rpm
Y: IQ (conversion factor 0.002941)
Z: Advances main injection (conversion factor 0.015625), has to be read to the contrary
Cattura.jpg
ok I see...it seems like I have seen pi? times that map
anniver I don't know what you can do I don't know with which file you're trying...cos? eye I can not tell....there are so many of those limiters in these maps....
But ? the map immediately after the two torque limiters to panettone,that is from the ecm?
The one posted by riccardo, does not seem to me to be the advances...
About the limiter, ducati, give me the address that you have found and the link to the file please?
Why? no?Originally Written by Danny
The values and increments to correspond with those measured in diagnosis.
then as the file is fine any 70cv, for addresses, do a search with a decimal value of 5500...they are two close to each other as shown before....and to be certain there are also two limiters rpm minimum 750 always close to the other 5500.....if you have difficulty? let me know.
No, it's not ? that, on the file of the point ? address 0667B0
The advance on file of the point 1065P351 is 667B0
anticipo_667B0-1065p351.jpg
ok ? the same also for other 70 hp, the only question....it should be read to the contrary, the whole, or only the single curves?
Write permission
Quote