Write Marelli in serial with COCK V51

[passione motori]

then I'll explain what I know' , if you read the whole of you reads the file, 2.5 mb ( and there is like 1 hour to read it) if you ( like I do) you do it in the bdm you put nothing in the laws from 2 mb and you have all the bck of the ecu and then tranquilo ,I usually open are not units mangy ,but I know the file is 2 mb you don't read from serial port

and if the laws of a table the file which you find yourself ? 2048 Kb

[desmoric]

my problem is not ? read the ECU, I read on the serial line (via OBD2) is a table and I got a file 2,048 MB) and whole (and I got another file 2,560 MB), and so far everything is ok.
Now I have to write the MOD file (I have done defappare, egroff, and map corrections from the on-line service)? 2,048 MB.
- can I write it to the serial (via OBD2)? or do I have to write for the force in the bdm?
- do I have to set something to write, to write it in the "mode? not complete" like me ? was recommended? the ioc?... the same choice that I have read (tabular/full) I have it also in writing?

[passione motori]

I'm sorry, you have already? recommended you read the table and re-enter the grid via the obd before do-ecu data, then open file, select your file, check the entry in the table and then write and follow the procedures that the sw asks you, make sure you have the battery of the car great charge.....always above 12 v

[desmoric]

ok now I ? pi? clear, thank you
? that first I was wondering to write and you to me rispondavate for reading.. no polemic, but rather are here to clear my doubts and to learn.
thanks again
hello

[fire]

as you do it from file 2.5 mb of the rooster bring it up to 2.0 mb? I ? happened the same thing on a msv70

[passione motori]

Fire, try using the search button at the top of the page, or open a new discussion and make your requests, a read to the regulation will aid you? not to make mistakes....

[leandro89]

as you do it from file 2.5 mb of the rooster bring it up to 2.0 mb? I ? happened the same thing on a msv70

as a gi? said by passion motors, make search and you will find everything you need

[marco_evolution]

just cut the part about the mpc that ? that 512k more you find..Anyway if you've read the file on the 2.5 board my ? change those and rewrite it..do it directly in 2d if you don't want to do copy and paste, especially if you ? at the beginning you may make some mistakes that could ruin your day

[marco_evolution]

however, re-reading the discussion ? strange that cock you have read the file in kline to be more specific 2.5 mega usually is only virtual...

[nolaru]

just cut the part about the mpc that ? that 512k more you find..Anyway if you've read the file on the 2.5 board my ? change those and rewrite it..do it directly in 2d if you don't want to do copy and paste, especially if you ? at the beginning you may make some mistakes that could ruin your day

Sorry... what is "mpc"? And for that you have to cut? I too have read 2.5 mb from siemens msv70 but I intend to write it on not so great as it is.