ECU Chroma error P0641 and P0651 control unit faulty or eeprom corrupted?

[sdipi]

Are in the province of Naples,
I confirm hw 0281012961 and sw 1037386777

Unfortunately, for now I don't have a BDM interface... I only have the programmer eeprom...

0281012961-1037386777 is missing a piece

unfortunately I can not see the attachments.... that means missing a piece?
the file of the eeprom is not ? complete?

Thanks to all

[cinqueturbo]

Or realized that you are the province of naples, but where are you exactly?
maybe you're two steps away from me,
while one takes a coffee? we put in place is the ECU...

[blackwolf76]

I don't understand mil which is why one of them starts to unsolder, sladare and combine sti casini when you just need a bdm, also situated by the chinese in the middle of the road now...

Anyway, when that type of error means that you did not correct the cks in the file you uploaded.

[sdipi]

I don't understand mil which is why one of them starts to unsolder, sladare and combine sti casini when you just need a bdm, also situated by the chinese in the middle of the road now...

Unfortunately I am a novice in this field
For this type of ecu ? just a BDM100 V1255?

Thanks to all for the help you are providing me.

Anyway, when that type of error means that you did not correct the cks in the file you uploaded.

Studying a bit the kind of errors do not are convinced that it is a problem of chk or wrong file, but I'm convinced that this is hw failure of the ecu.

The errors P0641 and P0651 are errors power sensors 1 and 2.... (the power supply that generates the ecu if I understood well).
I think that if I had the cks wrong I had to have P0601-internal memory checksum error...

What do you say ? correct this theory??

[dom86]

perk nn try cn checksum corrector ke t coast try

[cinqueturbo]

I'm wrong or I BDM100 or Rooster reads and writes only 4KB and carprog and conpani 8KB?

[sdipi]

I'm wrong or I BDM100 or Rooster reads and writes only 4KB and carprog and conpani 8KB?

I read that some files need to be cut to be used with different interfaces (as read in from the serial port and write to the bank).
On the forum there are several posts on the subject, or am I wrong?

[cinqueturbo]

I read that some files need to be cut to be used with different interfaces (as read in from the serial port and write to the bank).
On the forum there are several posts on the subject, or am I wrong?

But in the case one to your problem of corrupted file thing cuts?
how to write a partial file with the cut side and still remains the part corrupted before?
and while peering or seen that the soft immo on these EDC16C39 are not very clear on partial on the e2prom in my possession..

[legendaryslave]

to him, you need a good read of the ecu of the e2p after that with the programmer bdm or any instrument rivergina, and sets in motion both the file of the cmd does not ? other than the file that is read by a programmer or doubled

[cinqueturbo]

to him, you need a good read of the ecu of the e2p after that with the programmer bdm or any instrument rivergina, and sets in motion both the file of the cmd does not ? other than the file that is read by a programmer or doubled

Ok grabbed,
merely come to doubt because of the difference of magnitude,
then comparing my 4KB and his 8KB I realized that his 4KB everything to ff or 00 now I can't remember..
another doubt comes to me with that SW can you? do a partial?
tai my non c'? partial, but only the total, and adiri tura on the flash?...