Hello all,
kindly I need your help I have made a bit of a mess....
EDC16 0 218 012 961 Chroma 120cv
After unsoldered-bed-written-welded to the eeprom 95640 the car does not start and the diagnosis has the following errors:
P0641
P0651
I doubt that the file loaded in the eprom is corrupted since vlc does not recognize it.... someone can? check?
Do you have any suggestions/test you want to run?
Thanks
EDC16 Croma Mj.zip
why? you've done this?
reload the original file...
and check the welds and the positioning even before...
I was trying on some equipment (digiprog and carprog) as readers of the eeprom.... and unfortunately the one that I have attached ? the file "original" (the first bed can be seen).Originally Written by alfajtd
I redid the whole not changing the file, and unfortunately not ? changed nothing...
Can I try another dump?
you have to find the same ecu with HW and SW, if you have not broken the eeprom and/or welded evil or read bad..
I don't think is welded evil even why? from diagnosis, the ECU can't read the parameters (such as KM, etc) that are contained in the eeprom... the only errors present are P0641 and P0651.
I think that you have misread the eeprom... I can load the dump another Eprom of an ecu the same? Do you have any dump that I can try?
C'? someone on the area of province of Naples, or that I can? help?
Last edited by leandro89; 27-02-2014 to 20:47
Mail HW SW..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
0281012961-1037386777 is missing a piece
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
anke wanting to help you can not download the file, you must have prior permission from the superiors
Or a full Backup...
what part are you from?
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Are in the province of Naples,
I confirm hw 0281012961 and sw 1037386777
Unfortunately, for now I don't have a BDM interface... I only have the programmer eeprom...
unfortunately I can not see the attachments.... that means missing a piece?
the file of the eeprom is not ? complete?
Thanks to all
Last edited by leandro89; 27-02-2014 to 20:47
Write permission
Quote