Sorry for a question, on this unit, and you can get the vergin ecu with the cock 2 or serves other interface? I have never put a hand, but I have just yesterday asked to transform a unit of panda fiat 600
Sorry for a question, on this unit, and you can get the vergin ecu with the cock 2 or serves other interface? I have never put a hand, but I have just yesterday asked to transform a unit of panda fiat 600
you have corrupted the e2p and hardly restores according to me I try with piasini, or as I have said agg in fiat, have you tried the tool decode to do rivergina? PROOF.
Should I then try to do rivergina with the decode 59F?
Originally Written by giuseppe1374
You can't do rivergina because the tool does not make me the most? ID.
I did not understand what was recommended to do cinqueturbo.
Last edited by leandro89; 11-02-2014 to 21:14
Hello mauro I don't know if you fixed it but I would try to write it with mpps responsible for executive directly to the ecu I think that you should solve, and maybe you would not have that error.
What do you mean? All the tests I've done responsible for executive directly to the ecu, which is at the desk.
Did you write it to the bench with mpps to this I was referring to
Restored!!!!!!!!I don't understand how it happened, but I tried again in the boot with the galletto 1260 and this time ? all went well. The same interface, a few weeks ago (when I closed the scruttura), the same procedure but this time he has completed writing. I've even rewritten the original file with the MPPS and written without problems.
I know normal I forgot to tell you this, but from what I read it did not seem like your case..most of the times after you get 100% the rooster takes about fifteen minutes to finish the writing, I believe, really hard to correct the checksum happens more with me 59f with hw<100, and not with hw>100, you have the complete file and the cks ? ok.
It is, in fact, was not my case, as I wrote a few posts above gave me this message
with the Galletto V2, after the recognition of the ECU, if I tried to write gave me the message
"WRITE the ECU
Initialization write...error erase"
With the Galletto 1260, after the recognition of the ECU, instead, began writing, and then it comes to 100%, but it gave me the message
"WRITE the ECU
Initialization write...ERROR Change speed?"
Obviously, don't give up
important ? that you have solved
Write permission
Quote