Reading in to boot, these units give you two files: a file of the e2prom and the file of the flash. To read in hexadecimal are similar to version .bin or .exe. If you notice that they are totally differents, in particular the area of the electronic label, it means that ? totally gone and you might as well try to pick her up, only with a file taken from another part. Try to read it in the boot and see what pops out, now at this point you can do is try.
M999
Do not step files and more in private!! Post your requests on the forum.
Here is the map that I was able to read in the boot, in case someone wants to check, I tried to rewrite it in the boot but you can't.
the file that you posted ? completely corrupted flash and e2p and not ? even the bed in the boot strap
if you want to save the ecu do it before to go at a center-fiat and do ecu upgrade engine and restores
.......that is too simple.......and I, with what game?Originally Written by crteam
Certainly that ? in the boot!!!!!!!!! Made with my little hands.
However, I did two readings with the Galletto V2 (and they were the same) and the other two readings with the Galletto 1260 (and they were the same); it's just that the readings made with the Galletto V2 were not equal to those made with the Galletto 1260.
The attached file ? the one bed in the boot with the Galletto V2.
But ? normal that the file is corrupted you can not write it in the boot? Or the problem is in the ecu
for starters you could use a few exclamation mark in less, I did not say that I would not put it in the boot but that the ecu is not ? went to boot!
the file ? corrupted both e2p and flash! searched for a file in the boot and compare it with yours and see, your problem ? that you have cleared the first part of the e2p
and the restore ? difficult is this ? the file test.
well since ke you said that you have a problem doing as I say, you solve it.if you want to play and another speech.good game..........that is too simple.......and I, with what game?
Certainly that ? in the boot!!!!!!!!! Made with my little hands.
However, I did two readings with the Galletto V2 (and they were the same) and the other two readings with the Galletto 1260 (and they were the same); it's just that the readings made with the Galletto V2 were not equal to those made with the Galletto 1260.
The attached file ? the one bed in the boot with the Galletto V2.
But ? normal that the file is corrupted you can not write it in the boot? Or the problem is in the ecu
Instead of a few exclamation point there was some smiley face..........for? the discourse that the unit is not ? went to the boot ? quite strange, since when does not boot the sw you said to me a couple of times ? get the message with which I reported, "control unit in the boot" (or something similar).
However, with the four readings that I have done with Galletto V2 and Galletto 1260, the screens were exactly the ones in the boot.........there? that said, the fact remains that file ? corrupted (I checked and you see that ? abnormal).
Thanks for the file!!!!!!!!! I try to write it down and place the result.
But with the tool fiat rooster v2 to try?
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Sorry for a question, on this unit, and you can get the vergin ecu with the cock 2 or serves other interface? I have never put a hand, but I have just yesterday asked to transform a unit of panda fiat 600
Write permission
Quote
