Solution hardware failure galletto v2 ver 52 3 led

[motorsport]

ok you have been very clear another thing that is important to where to buy these components???

[davidepar]

I hope that I bannino for this ....I'll just tell rs.....the rest you think about it!!!!!!!

ps to admin I hope I have not done damage.........

[Macchinista]

Changes made!!!! All ok!!!

The ecu EDC15C7 that the other time he would not know to read, this time he has done it all!!! Thanks to all for the help and the parts list. I thank, in particular, the user giary74 for helping me!!!

I replaced:

Condenser: - 470 mic
- 330 mic
- 100 mic
3 Resistors SMD: - 470 ohm
- 1.5 kohm
-1 kohm
-3.9 kohm
-120 ohm
Integrated: - HEF40106BT

Quartz: -16 Mhz

[net_proo]

hello,
you can? explain more? clearly in the picture plz

[giary74]

Changes made!!!! All ok!!!

The ecu EDC15C7 that the other time he would not know to read, this time he has done it all!!! Thanks to all for the help and the parts list. I thank, in particular, the user giary74 for helping me!!!

I'm glad that you managed in the enterprise!!! Bravo!!

hello,
you can? explain more? clearly in the picture plz

You can not see the attachments, why? you still have a few post, but if you read carefully a few pages back, you'll understand how to do it.

[Macchinista]

What do you mean by pi? clearly? Unfortunately, like me, you can still see the attachments and then do a search on the web as indicated in the previous post and then tell us your doubts if you still do not you ? clear what to change!!

[net_proo]

hello, ? my Galleto 2 photos
IMG_0762.jpg

[Macchinista]

hello, ? my Galleto 2 photos
IMG_0762.jpg

I'm sorry but I can not understand your request!! And we will have to wait for someone with more? messages me, why? as I have already? written above, I can not download even attachments!!!

[Macchinista]

Guys today I ? happened a bad thing. After the change I have read a ecu I did id etc and all was well. Then the cock ? stopped for 2 days. Now today I had to read a car but surprise the cock connects to the pc but in the software it is as if it were plugged into the obd. is all gray and writes low tension is not letting me select anything. I have already? tried to connect it also to bamco but same result. Do you have ideas on what can? to be success??

[sisco]

some of the time ? happened to me but after it was unplugged from the usb port and have it reattach it ? resumed