Legendary excuse me but do not open l annex for he says that I do not have the privileges you should upload it as he did, blond, i.e. the picture in the post....thank you
Legendary excuse me but do not open l annex for he says that I do not have the privileges you should upload it as he did, blond, i.e. the picture in the post....thank you
search the web ? you will find the photos how to put in the boot, the ecu...Originally Written by skizzo93
as required by the regulations and is prohibited.
[IMG]http://bannerbreak*****/banners/3/563/135700419269659378.gif[/IMG]
[IMG]http://i40.tinypic*****/2mwf9xu.jpg[/IMG]
C'? a little bit of "jelly" in the contacts, proceed with caution.
I had the same problem a long time ago and I wrote with this technique
Boys but I'm thinking if you look at the ecu with ol cock in me.programming 1 in 2000..so the ecu was already written once... so even if you already have programmed a time when I have to open???
The guys then??? There no one that can help me??? When I put the pin 10 to+12v and ask the ecu data with the rooster does not change anything...sikkome I'd read somewhere that the log changed perhaps, then, the ecu is not really in the mode of writing??? Maybe the gel does not touch well the needle that I used to send +12v....
Open the lid of the ecu and make the boot process indicated above. Cos? you will be able to write without problems.
The boot, which you get by opening the ecu, as I have indicated behind, you recognize why? from the info of the cock to get additional information compared to the standard procedure.
you have to put in the boot with a pin to ground inside the ecu as the photo's? no, not the law!!!!!
Write permission
Quote