tonight I write to you as you try to remove the speed limiter
tonight I write to you as you try to remove the speed limiter
Not the upload, it seems that you have increased 10% advance!!!
the rest seems ok
Waiting for someone more experienced
Excuse the error, I swapped out the map ED150 with a map in advance, instead ? lambda. As ever, you have increased?
Last edited by leandro89; 18-01-2014 to 13:03
hello franco, you do not worry for your oversight happens I I was wrong to increase the map? sincerely I realized that must be made in the negative that map but I have not figured out how to be done if you can read in the other page there are written the various doubts then I do not understand why the engine 2.0 dell audi on the map lambda uses values around 1000/1100 instead, this map has peaks up to 2000Originally Written by franco75
someone told me that the map lambda goes all around on the 950 as a flat line as he did munro what do you say c'? someone willing to give you a hand
anyone willing to give me a hand
Last edited by leandro89; 24-01-2014 to 16:21
try to 950, if you smoke the fix
today I tried to put the 950 and change the map conversion tomorrow we know some quick hoping positive even why? the machine had a lot of the lights are on but apparently due to other problems, something I removed in diagnosis other should be placed in and then the car had already the problem that the phallus up and down of the rpm pero according to diagnosis, the injectors are in internvallo - 0.5, and more 0,5 then they are fine now I have to figure out how to keep under control the various values
Hello, I will advise you to do a complete log with a self-diagnosis of the good type autocom or delphy, then the problem will be the machine I would like to know in the meantime if with the original map you from?
hello thank you just yesterday evening we made the diagnosis with delphy l car in neutral salt of turns and lowers the same happens in the values of the injection anyway, doing a test by holding the pedal slightly crushed remains constant so it's good for? of course, you have to understand how to do to fix it .. then when I made a new modification of the car the car goes very well for? if it sinks exceeded the 180 goes into recovery the diagnosis then this error DTC Description
16618 - Control pressure loads; control limit exceeded
so the car then no more good then you have to turn off and turn on the engine and you solve the problem, but of course the diagnosis report this problem . however, if you accelerate gradually does not this thing happens, but of course with the plan
then lowering the pressure to the turbo the car should be the same in recovery so I was forced to put the map original oxygen consequently, the recovery is not c'? poiu for? the car makes less c'? someone willing to give me a little help
find the compromise right with the map, lambda, abbassala less. Prior to? system the turbo as it should be, as by varying the pressure changes the air flow affecting the map lambda.
Write permission
Quote