bosch me 1.5.5

[biondo83]

Sisi perfectly what I have taken. ...at this point the only explanation, and that did not touch the pin on the pin... putting it in the boot, to be sure before writing lights that I know the written code (type the me 7h4) or perhaps by querying the ecu with the cock appears to be something that makes you understand that it is in the boot??? Anyway, thank you everyone

If I remember correctly, you should see in the info of the Cock, a different log than what you get in the standard terms and conditions.

I think I have seen an astra 2000 gasoline......

I knew that:
The opel (Astra, Corsa B, etc.) assemble ME 1.5.5.
The alfa/fiat/lancia assemble M 1.5.5.

I'm sorry, m? that type of control unit, you must first put the boot on the inside of the controller (on the bench) to insert a file to unlock it and then log in as shown in the photo of biondo83....

Depends on the type of HW and SW of the ECU.
Some versions of HW and SW can't write them with the simple procedure to boot the external (without opening the ecu).

[scinti]

I've been following this discussion, why? for me ? very important ,only something is not right: you are sure that there is the me1.5.5? still another small doubt,the pin 10 must be connected to ground for the boot or on the positive, thanks and good job to all

[skizzo93]

Then 1.5.5 me there is but and opel (I was wrong I at the beginning of the discussion to type).... l alpha mount the m1.5.5 and pin 10 connector (or the one that has the identification numbers to the ecu side) should be attached to a positive 12v....

[todos]

I'm sorry, m? that type of control unit, you must first put the boot on the inside of the controller (on the bench) to insert a file to unlock it and then log in as shown in the photo of biondo83....

[skizzo93]

I did not know....????...

I k now I think of me is strange....the cio? if alfa can I do an update I have to remove the ecu get it to boot to the tour, etc??

[scinti]

Are you sure that the opel fits me 1.5.5, sorry if I insist, can you tell me which opel mounts it, thanks.
Still I ask to the experts, the boot pin 10 goes to the negative or positive thanks to all greetings.

[ducati83]

Are you sure that the opel fits me 1.5.5, sorry if I insist, can you tell me which opel mounts it, thanks.
Still I ask to the experts, the boot pin 10 goes to the negative or positive thanks to all greetings.

I think I have seen an astra 2000 gasoline......

[skizzo93]

The pin 10 goes to 12v to enable the writing and not the mass....raga in short, I don't know why it gave me that error?

[legendaryslave]

listen to me using this boot as it is put to ground and you'll see how magic can you write it

[todos]

listen to me using this boot as it is put to ground and you'll see how magic can you write it

I agree with t? are open the ecu ? put in the boot...