Hi to all, this ? an ecu removed from a volvo V50 2500 turbo diesel, engine T5, I confirmed that it is a Bosch ME9?
does anyone have the pinout to connect to the comb?
To open it and get her in the bdm should be opened from the label side or from the side of the fins?
thanks to all of you.
The ecu ? a me 9.0
ok thank you, do you think this pinout ford me9 it is also good for this volvo?
Pinout VOLVO ME9 and that is different than the FORD.Originally Written by ducati83
Regards
BogdanS
hi all, today I finally decided to open the me9,0 of the volvo for the reading in the bdm,and unfortunately I found myself in front of this problem:the ecu opens to the contrary....then the part where you find the pinout of the port bdm ? below....I tried to remove the screws and cut the perimeter of the sealant but the nda seems to me your buried in the sealant...at least from how I see in the various photos of the edc16 by the documents of the bdm....
advice?
you, in fact I have left to lose why? are not able to remove the under side of the ecu....and I didn't want to risk it.....advice?
unfortunately, I do not use your own equipment, but where I use gallo ori.....and I have a chicken for a few work fast......the fact that they do not have to open anyway ? a great thing....even if I often don't trust them not to open the ecu unpalatable or that are going crazy....of course, it would test everything and then I could also say that with the support behind me, I would avoid the work.....
anyway, the fact remains that this blessed ME9 not ? he wanted to open up....
Write permission
Quote