From what he had understood wandering in the network was ke the m 1.5.5 could not be read even in the boot with galletto 1260..
From what he had understood wandering in the network was ke the m 1.5.5 could not be read even in the boot with galletto 1260..
I do not know....but I would do as you have suggested: read your and then you change it...you never know....then posts them here on the forum, you will be sure to give a lot of tips to get one alone, and that it is done well....even why? a petrol is not ? so easy to do without doing damage if you don't know where and how to touch....
I do not know that there are tools that read the m1.5.5 of the alfa ts, not even in boot
if anyone knows them I would like to know.
the ecu ? a m1.5.5 and not me1.5.5 as indicated at the beginning of the discussion
I remember that to me the 156 a dozen years ago made it without removing anything......only put a pin comb mass and then everything from the obd....
maybe not had a m 1.5.5 but maybe a me 7.3.1..... then, as I knew you can only write by putting into boot mode.... with regard to the reliability? the ori found the network I had, I fear, but at the end of loading it without driver with the ecm is giving me the same numbers of HW and SW...so I think I can be quiet
if it has the same HW and SW you can trust
sorry guys I did not understand a thing....the 12v on pin 10 must be present even with the ignition switched off (for example by taking them directly from the battery ) or do I have to be present only with the ignition switched off?
then I tried to download the map. I put it in boot mode(I sent 12v constant taken from the battery positive on pin 10 using a needle that would go into the hole of the comb to which was soldered a wire), the voltage of the vehicle was to 13.20 volts I connected the wing,I turned on the framework,I selected my file bcb when I download the file the rooster as always informs me of how to put in the boot for? because apart from the pin 10 said to me:" pin10\8"???) I gave up sending me ? released: "cancellation.....seedkey error"... What does it mean???thanks a lot
Guys? ??
Last edited by leandro89; 27-01-2014 to 21:40
Sorry how do I do this?? Why? where were the codes and cleared it only reads 033 but I have the numbers hw and sw..I don't think even ke maybe it can be a me 7.3.1 why? the pc me the questions well with 1.5.5 .
HW 0261206061
SW 1037350386
Thanks for your help....