I can confirm if mpps v12 you can at least write it?
I can confirm if mpps v12 you can at least write it?
You Mpps writes it, but you can't write another SW..Originally Written by ciullo.eugenio
Mpps writes only a portion of the file not the entire...
Then after writing see the flashing engine failure, normal,
do warm up the engine, and make three lunges at limiter and spegnei...
??? sorry... I did not understand
in what sense is it off? x?D I did not understand if it was ironic, I'm sorry xD
if you follow it to the letter, after this procedure the engine is switched on? not ? that fund?
Wait a minute you have to work on a IAW5SFHW300, I was convinced that it was a IAW59F..??? sorry... I did not understand
in what sense is it off? x?D I did not understand if it was ironic, I'm sorry xD
if you follow it to the letter, after this procedure the engine is switched on? not ? that fund?
But you have failed to read from serial port?
Last edited by leandro89; 25-01-2014 to 11:47
you ? a 5SF3.M1... then I did not understand one other thing, the program asks me to calculate the checksum <- you give me insights about it?
you're running too.. better explained in that phase? in the process of writing?
no, I was not able to read it in no way possess only mpps v12, and I do not read apparently
so maybe even if I can find a file ori, I would like to know if once mapped (using ecm titanium) if I can at least write it with this interface since you don't want to know, read...
another question, if I send in the boot is the control unit, connected drive, and connecting mpps on the obd can be read?
to write can I write it so? quietly or do I have to send in the boot? by obd you can do these 5SF3 say to you, at least write them...???
Be careful on the screen of the sw indicates whether cks calculates it automatically or not,if it calculates it automatically you are affixed, or do you must do to part with another program!!
You do not really understand something until you can explain it to your grandmother (Einstein)
you're going out of the way..
then put in the boot this ECU you have to solder the resistors to the internal and feed the ECU on the bench not on the car,
with mpps can be read in boot but however, you have to connect to the pins of the ECU and food both.
it is not difficult but you just have to ingeniare all on the bench with power supply and connections on the ECU...
do not lay hands on it if not inkiodi!!! buy piasini and dedicated to the ecu..with cock-v48-51-53 I failed ..with piasini go quiet, you can do all the tests that you want a time that you read..!!!!
What is a hare? A rabbit Abarth
Write permission
Quote
