Problem reading edc15c7

[blackwolf76]

In the meantime, I studied a little bit around the net. Is the ecu not doing the tour if you do not disconnect the eeprom... which without key code blocks read and write, even in the boot.

[todos]

In the meantime, I studied a little bit around the net. Is the ecu not doing the tour if you do not disconnect the eeprom... which without key code blocks read and write, even in the boot.

I'm sorry, this unit can read and write in three ways,very simple, serial, tour you need to remove or scodificare the eprom, I have a programmer x the flash by removing the flash ch? it would be am 29f400.......

[cinqueturbo]

if you want to read it over the counter without a boot you have to remove it, then you have choices.

But it is certain that I do in Boot-Mode..
what sense would it read from the serial-to-tour?
read in Boot Mode and as a Backup, you are covered by any problems...

[motorsport]

Remove the flasks do it before!!

[nox]

I boot I have made 5-6 without removing e2p it does not cost you anything to the photo, and the one in the folder of the rooster calls edc15c7 hiunday

[blackwolf76]

Bench-nothing to do without removing the eprom, not even in the boot.

[nox]

I would not insist but see if the steps do it right because if you mess up the way and the time to remove the wire to ground the reading will never do because it will detect the system in the boot then arrived to the point I am when you're about to hit the head dissaldala

[carlo abarth]

this ecu and this machine body section??? the code will turn off when you go to read it??
if you do not remove e2p not the laws!!

Hi,
I have a problem with a edc15c17 of the stylus 115hp. In practice, I have to scodificare on the flash? I can't read it under the car and not even on the bench. The cock makes me ecuid and all the rest, and in the time to read it gives me error. Same error with both gallo1,gallo2 and mpps. Maybe I miss it or something might be broken??

Grassie.

[blackwolf76]

As written before the ecu ? of the other machine to mount on this that has problems on the accelerator pedal, and therefore I can not read it if you do not desolder the eprom, since that will not unlock if you do not have the code open.

[ugoboss]

As written before the ecu ? of the other machine to mount on this that has problems on the accelerator pedal, and therefore I can not read it if you do not desolder the eprom, since that will not unlock if you do not have the code open.

and what aspects to dissaldarla, it takes 30 seconds, and at this time you had already read and written.