from what I understand around should be made in the boot given that if you do not unlock the key does not act on the tour. But which protocol should I use??
from what I understand around should be made in the boot given that if you do not unlock the key does not act on the tour. But which protocol should I use??
In the meantime, I studied a little bit around the net. Is the ecu not doing the tour if you do not disconnect the eeprom... which without key code blocks read and write, even in the boot.
I'm sorry, this unit can read and write in three ways,very simple, serial, tour you need to remove or scodificare the eprom, I have a programmer x the flash by removing the flash ch? it would be am 29f400.......Originally Written by blackwolf76
Remove the flasks do it before!!
You do not really understand something until you can explain it to your grandmother (Einstein)
I boot I have made 5-6 without removing e2p it does not cost you anything to the photo, and the one in the folder of the rooster calls edc15c7 hiunday
Bench-nothing to do without removing the eprom, not even in the boot.
I would not insist but see if the steps do it right because if you mess up the way and the time to remove the wire to ground the reading will never do because it will detect the system in the boot then arrived to the point I am when you're about to hit the head dissaldala
this ecu and this machine body section??? the code will turn off when you go to read it??
if you do not remove e2p not the laws!!
What is a hare? A rabbit Abarth
As written before the ecu ? of the other machine to mount on this that has problems on the accelerator pedal, and therefore I can not read it if you do not desolder the eprom, since that will not unlock if you do not have the code open.
and what aspects to dissaldarla, it takes 30 seconds, and at this time you had already read and written.
ugo ---- president A.E.P.
Write permission
Quote