perfect!! thanks guys you have been very clear!!!
perfect!! thanks guys you have been very clear!!!
I forgot that for the dense if you must make them by welding the wires, and a large break of..... there are about 10 wires to solder to read and 10 to write.
Last edited by msport (exil77grande); 29-12-2013 at 12:15
Unshared knowledge remains an end in itself.
hello guys, as you do for the marelli 8df? I'm looking on the net but I can't find anything specific, I was thinking to build it, you advise me something???
If you have the desire and time to the build, but once you've taken manualit? solder does not ? then cos? difficult.
Ditto for the dense
So the only solution and build it or change un9 of the old series...
I have seen some diy for 8df, and it does not take much to thick I think we want a little more, so far I'm welding.Originally Written by rdponline
ugo ---- president A.E.P.
Watch it doesn't take much to build them, you buy the board, the copper, here in my part 100x70mm paying 2?, make the design of the circuit with paint the ports have a hardware store that also makes the plates and the game and the fact, in an electronics store to buy needles and grafts to the flat, balances everything... and it's done... but if you find a trade already beautiful and done and much faster...
Hello, x-8df I use the old board of the cmd with the cable adjusted to the pin...
Well I think that I will do so
if the old ticket cmd, do you mean the usual schedule bdm, you can't do this because the pinout is the same of the e xxx is different, and also changing the position of the wires on the pins of the original does not cover the links.
ugo ---- president A.E.P.
Write permission
Quote