nothing changes the v 53, and only the clone v54 original and it is enough to buy it and go quiet a v53 of the good ones here in the forum if you go to the section fgtech you can see all the users that have purchased the various programmers, including I me the other day ? here and there I do all the work in serial to tour safelyOriginally Written by dreamc85
this programmer involves removing the eprom from the control unit to be able to remap or you can create a copy of the eprom on the pc to work with it and then load it later?
The rooster v2 ? a programmer that allows you to work through a serial port or via a cable to the obd and then in the package you will find a set of cables that allow you to be able to use bdm boot mode, jtag according to the type of ecu you have to do, and possibly the mode? you want to use to be able to work, and in the folder of the programmer fgtech find a set of patterns with photos on how to work and on the connections to be made for many different types of ecu for? I can also say that a serial port or cable takes a lot of drive and has a car park very large including the new ecus talking about the version v53 clone and what is important for? ? being able to find the right version that really works why? in the network there are many sellers who sell but also true of many who sell poor quality I for example, I was lucky and I found the version that works perfectly in everything but if you go to the forum in the section fgtech you accorerai that I have also posted a photo with the inside and the chips of my cock, and I can tell you that it really works as what the user has sportknight to me you have to think that in just 3 days I ? arrived ;-)
but how much did it cost?
I am here in Italy, he bought 250 euro including shipments shipment from a chinese and I can tell you that I have found, as I said, very well
it seems to me spending a p? excessive if I just want to try to try to remap, especially the perch? ? the first time that I try to do these things, you who say to me?
On the contrary, I can say that the expenditure ? absolutely low indeed starting to work with a good tool and professional that allows you to do everything in most of the cases, and in the pi? you risk a lot less inferiuori than a tool of a few money in addition to make you risk blocking the ecu or to the pi? the money that you have to spend out of pocket to the customer then you will be forced again to redo the expenditure of a good programmer and not worth, in my opinion, worth spending twice their money for the same thing and then still a lot of work on the pi? quiet with a good tool for this ? the first thing that matters
I was opting for the kwp 2000 due to the fact that I find for a 25 euro... you tell me that ? to throw money unnecessarily?
But this has nothing to do with the rooster v2 if you need to work I have given you my advice, take the cock v2, then do as you want but the difference there is, and how
Apart from the fact that with the kwp 2000 can't do nothing in comparison to the gallo v2
Write permission
Quote