the fiat bravo is not part of the problem can line

[gero]

check carefully to see what it says obd75 and happened to me twice in the handbrake lever, pulls the plug out-of-control cables are not loose

[obd75]

gero did I mention,the wires in the pettiene you on the runway.
hill holder ? a function always of the esp should be a assistenta for pastenza from a standstill or uphill"should not put my hand in the fire", however, f? part of the esp

[gero]

just what obd75

[robby51039]

gero did I mention,the wires in the pettiene you on the runway.
hill holder ? a function always of the esp should be a assistenta for pastenza from a standstill or uphill"should not put my hand in the fire", however, f? part of the esp

though I tried, I pulled the wires on the socket(I happened on the other car) but it's ok
I want to set fire to it!!

[obd75]

do not remain other that to exclude the can line (wires green and brown)how are you ? the state recommended starting at the abs and then to the sens.yaw etc..
if one of the devices disturbs or cancel the signal can all ecu's can not work.

[progresso]

hello can line and so connected: BODY > ELECTRIC DRIVING > NODE YAW> NODE ABS> NODE, the ENGINE control UNIT, the body can't diagnose it? if yes, which dtcs are there? in the other nodes that dtc did you? you can proxare and see which ecu you to configure, and then the problem will be, or in the power supplies of the same or in the links can
shared on the network

[robby51039]

hello can line and so connected: BODY > ELECTRIC DRIVING > NODE YAW> NODE ABS> NODE, the ENGINE control UNIT, the body can't diagnose it? if yes, which dtcs are there? in the other nodes that dtc did you? you can proxare and see which ecu you to configure, and then the problem will be, or in the power supplies of the same or in the links can
shared on the network

thanks so much,this link I had already found and tried(ok) I also put two wires to the right from the body to the ecu the engine to avoid wiring problems
the ecu can not find dtc,in the control unit body does not communicate
today I found out that this car had the battery interotta......this makes me think of strange spikes of voltage in the negative as positive......in the whole network
I think that all that remains is to try to replace the body and the ecu what do you think??

[gero]

I also believe I will try a body,if you make a diagnosis with the examiner you can see in the monitor the can network which are the units that are active and those that are in error

[michele30]

if the connections to power and ground and can line are ok ( well controlled ) would say to look inside the body or replace it,
have you tried if with jump-starting the machine? or diagnosis?
if you need to do the test with another body, not c'? history.

[claudio-abarth]

to me the big question every now and then is out of abs not available,esp not available,esr is not released,hill holder unavailable