MARELLI MJET impariamola!

[sportknight]

It seems to me that you do not read what I write. ....

[Danny]

S? but being as high as the limit does not send the drive in recovery cine on the 70, I wanted to say this

It might serve only if you want to exceed 1700 bar.... I would not pump standard

But xk? then I can't go over the 1460 bar? Riecso to increase the rail to the medium, but not to tall...I Speak of a Swift, and with the 75hp.

[mariodarkblue]

But xk? then I can't go over the 1460 bar? Riecso to increase the rail to the medium, but not to tall...I Speak of a Swift, and with the 75hp.

uhm...watch it seems to me that the swift has the same stuff 70cv...cmq, c'? definitely a block somewhere...but, who knows does not speak...

[Danny]

Of course am lucky it goes! I start going through the files dell gp 75 in comparison with that of my....Let's see if the cable something different

[Danny]

Swift again, guys, to find out what limits the rail to 1460 on the 75hp......!

[Danny]

honestly, I do not seems to be a map, and to verify, on the 75hp and 90hp bit is located in the initial part of the map

Annex 6071

Back, to enlighten me? In the screen you posted for the 75hp and their limits, and I do not see the area of the map rail..here you say is right before...can you give me a screen please?

[Backgroop]

Back, to enlighten me? In the screen you posted for the 75hp and their limits, and I do not see the area of the map rail..here you say is right before...can you give me a screen please?

Sn already? posted of the screen relative to the 75 and 90hp

[Danny]

But in the screen, between 75 and 90 does not change anything. I have the 75 and I will stop, however, at 1460

[Ela.Toretto]

but you have made, the variation of the famous bit?

[michele30]

raga I have a problem with the turbo of this car, I climb a hair above the threshold of 2500 mbar, and then go in recoveri, should I review the turbo but since ? my I am looking for the restrictor of the turbo, to raise a pochinio c'? no one that knows where it is?