Scodifica total bosch M 1.5.5 0 261 204 948

[special]

a greeting to all the members.. I should scodificare a control unit outlet demolition of an alfa 156 1.8 ts year 99
code bosch 0 261 204 948
family unit: bosch m 1.5.5

tests run: 1? trial serial mpps I tried to upload the file here on the forum for the scodifica total, which is connected to the ecu on the car and powered the pin 10 and checked that the voltage is higher than 13v attempting to load the file from the error probably why? the control unit having been recovered in the demolition does not read the key code is not allowing the writing.
2? test: I was able to write the file scodifica for serial writing ? took place on the bench in boot mode with fgtech but without result.


I wonder if there is a file to load the boot mode for the scodifica total or other solutions.

[legendaryslave]

Have you written to the file that generates the carsoft writing with the cock, and andataa good end

[special]

the file is written in boot mode with fgtech ? what you have downloaded from the database of file scodifica tested http://www.professionalchiptuning.ne...d.php?715-alfa
the gallo marks write 100%

[legendaryslave]

try with this do know, of course, off the box code

[special]

first of all thanks a lot really nice.. a question to load this file I have to upload it to the tour putting into boot mode ? write with fgtech or another serial right?

[legendaryslave]

In the serial-to-tour-with fgtec2 in bootmode

[special]

then loaded with galletto 1260 in boot mode and the car starts quietly but in diagnosis that by making the reading of the data with the cock to me by a bosch code which turns out to be a GTV 2.0 TS while the car in question, and a 156 1.8 ts 1999
a question, but this file ? was created with carsoft? if you give me a tip I could process the original file of the 156 1.8 ts
thanks again for your interest

[alexracing]

hello special I've tried to read the tour a bosch 1.5.5, but without results ,I use rooster v50,the cock,mpps,I could send you the pin out that you have used and also the procedure thanks in advance.

[special]

hello special I've tried to read the tour a bosch 1.5.5, but without results ,I use rooster v50,the cock,mpps,I could send you the pin out that you have used and also the procedure thanks in advance.

hello this is not for you to read, write only

[alexracing]

you I was wrong I wanted to say write it
I already have the file but I can not write it