vw polo ec15

[marcogti]

hello I have a problem with this car, who I can? check the cks of this mod file? the machine will not start. after dissaldo the 29f400 and I shot inside with the programmer, I would like to understand why? I gave this problem, the titanium says that ? file ? ok the family 36. I have noticed for? that with the old 6.3 is out an allert to save the eprom code for the start-up. Now, in fact, not part of it. I have read and written like so many other other edc15, the only difference being that this had not the fuse 11. is missing in contattiera. has read and written without removing any fuse, a p? as some of the a4. According to you c'? any way of priprenderla via obd or dissaldo and the party is over ? the rottora boxes ? the ecu is ? " locked " into a container with the bolts fracturing

[cinqueturbo]

To tried to rewrite the ori?

However, the cks and OK..
and s? it was a problem of the cks does not recognize ir? the ecu...

[ugoboss]

To tried to rewrite the ori?

considering that this is always the first thing to do in these situations, however, the cks is fine.

[marcogti]

You tried to rewrite it but stops and does not give me even the eoc id.

[cinqueturbo]

You tried to rewrite it but stops and does not give me even the eoc id.

but what with the read and write?

[faberecu]

please chk with winols
before writing to the bank , and still are a member of the Agip ? see a little bit of the q. fuel.... it seems to me exaggerated

[marcogti]

Use mpps has never given me problems on the golf with the same engine atd. X the cks winols I was working on x to install it.

I also tried to decrease the speed? but nothing.

[cinqueturbo]

test in Boot Mode read it before, and compares the read file with ori,
just to understand what happened,
then write the file ori and test s? ..

[danny677]

with the mpps try to make it go into recovery mode before trying to read ( even if not the id) just crashes do not turn off the picture, but from just ok to mpps and then write your file. If you're lucky, writes in the recovery and completes the operation.
Ill go act on 29F400

ah I forgot. try to raise the voltage of the job, perhaps by putting them on the cables from another car in motion.

[cinqueturbo]

ah I forgot. try to raise the voltage of the job, perhaps by putting them on the cables from another car in motion.

bad idea, the car in motion creates oscillations on the voltage...

or a great charge battery
or a battery charger stabilized...