Opinion on file YPSILON 70cv NEVERTHELESS 6JF Y1/HW01C/1092Y158

[Phantomat85]

Hi all, I have read the ecu of my ypsilon with mpps v12 and I would like to get an opinion from you.
My car has always done it a little more? the smoke of the other, since the purchase.
After a couple of years, I've made remap from a tuner (which has now closed due to the crisis), and before the close, I made it back to the original.
The problem ? that, however, is a lot of smoke too. I've ruled out the EGR, injectors, dirty mass air flow sensor and I ? left to check the ECU before opening the engine..
? everything ok?
Thanks a lot

[munro]

to me it appears that mpps v12 does not read the marelli mjd6jf....
however the file ? completely ori....

[Phantomat85]

to me it appears that mpps v12 does not read the marelli mjd6jf....
however the file ? completely ori....

You me to read it without problems.
have you compared the file posted on the forum?

[michell]

I confirm ...perfectly ori.....also the egr ori... anyway munro mpps v5 also reads very well y70cv.....

[nasone147]

Hi all, I have read the ecu of my ypsilon with mpps v12 and I would like to get an opinion from you.
My car has always done it a little more? the smoke of the other, since the purchase.
After a couple of years, I've made remap from a tuner (which has now closed due to the crisis), and before the close, I made it back to the original.
The problem ? that, however, is a lot of smoke too. I've ruled out the EGR, injectors, dirty mass air flow sensor and I ? left to check the ECU before opening the engine..
? everything ok?
Thanks a lot

Some suction laundry..or geometry blpccata..you have made an accurate diagnosis of all the parameters?

[munro]

the car has no geometry....
has turbine traditional...

[jovandj]

the car has no geometry....
has turbine traditional...

quotone has only wastegate, fixed geometry only an overboost electronic

[legendaryslave]

the car has no geometry....
has turbine traditional...

I ? happened the rust stopped, the joint of the valve

[nasone147]

Sorry..l I had also read 70cv!! :-D

[Phantomat85]

Some suction laundry..or geometry blpccata..you have made an accurate diagnosis of all the parameters?

I admit I was a little confused, then I have to restart from****..
I could try to do some diagnosis with the engine on...
Multiecuscan could do in my case?