Interface and software brera 2.0 jtdm 170 hp

[6bazz!]

Hello 6bazz,
we have hw and sw different, however, I don't think it changes the end result, any thing you ask?
The programmer did you get that?

123alexs

Hello 123alexs,

I saw that, unfortunately, we also have different hardware. I guess change little, in fact, and as soon as I read my ecu maybe we compare the files.
I was able to recover the backup done in bdm relative to your hw that is to say, made me feel comfortable in the case of the block unit. At this point, I would go with calm and first make a backup in bdm of my after ch? I would start with the remapping. For this I have not yet taken a programmer but I think I will follow in your footsteps by purchasing mpps as well as an interface to do the backup in bdm.
As I said, I would like to run exactly your work, so thanks a lot for the disponibilt?.
We feel!

6bazz

[6bazz!]

makes it but if I'm not mistaken, if you get a file that is read by other interfaces apoi dev i cut the file...

Hi sa80******,

sorry but I am not sure I understood what you wanted to say. Do you mean that I could use the map of 123alexs replacing it to my?

Thanks

6bazz

[sa80libero]

I just wanted to say that if you use mpps then you have to cut the file because if I'm not mistaken mpps writes a file from 1mb while the lters programmers 2mb around here.

[123alexs]

No... mpps on edc16c39 reads and writes files from 2Mb

x 6bazz: the files are not absolutely interchangeable

[sa80libero]

yes, I tested, and true writes to and reads from 2mb on edc16c39.
I 123alex, do not use other file with hw and sw different otherwise the plant....

[ugoboss]

exact writes the file to 2mb and if a file that is read in the bdm full of micro ti also writes that.

[Danny]

We do not create confusion.
Mpps writes the file to 1MB on marelli 6f3(75/90), and do NOT write on the group opel/suzuki.
On the eoc writes the law....

[gianlucacll]

We do not create confusion.
Mpps writes the file to 1MB on marelli 6f3(75/90), and do NOT write on the group opel/suzuki.
On the eoc writes the law....

Although with much delay, I say to you my a few days ago...
I have read with mpps 16 a 159 2.0 170cv at the time of writing, I immediately gave the error...
I thought that I had done something wrong and I tried to write gold but same problem...
The reading is made with the 1.9 150 in the k-line (the usual 40 min...)

[gianlucacll]

PS mpps reads files from 2 mbps but in reality it is not a backup... The first part of the file is empty...
But if I have a flash with the bdm is to write it totally? That is, write where it is not able to read?

[123alexs]

Don't give up at the first error and try again, on the 2.0 170cv if the law is sure that he writes.