opinion map new bravo 1.9 120 hp

[ecuboost]

c'? also the map is almost ready if you are looking for, I had made myself with the help of the whole forum

[jhonny]

Unfortunately I still can not download attachments, I took a ride in the forum, but I could only read the comments of things that encora, I can't see.

I use ecm 2001 to change, and to the addresses you mentioned I have not found changes, the same for the 22% of the couple that I do not see, and the ral is not 2%.

I'm not an expert, but to force that explodes you have 22% of torque already at 1000 rpm, the clutch enjoys
the maps pedal can increase only a 5%
the turbo is more or less ok
rail you are on the 2% I feel like I've seen you can also increase them a bit, maybe up to 4%
the maps 1e3264
and 1e3330, what are they?

to the addresses that you say I ecm2001 I do not find changes, that maps are missing?

to address 1C4B08 and 1C4BD6 rimettile ori.(many maps)

[ioni]

I use ecm 2001 to change, and to the addresses you mentioned I have not found changes, the same for the 22% of the couple that I do not see, and the ral is not 2%.

Check well, I see the same things said by another member. Above all, 22% of torque at 1000rpm not ? the maximum for the clutch...

[ioni]

Ah, I don't see changes at least part of the injection diesel, when I had made a couple of similar machines, I'd done a lot of work above.
That don't push the 1000 rpm according to me ? better for the clutch, then it is a question of taste on the drive way, for example, I prefer to give a little bit more? extension also to the diesel too much "blow" to the low...

[jhonny]

you give me the address of the 22% of couple that you see. I do not find it, I would not have attached a map to another...
also, to the addresses that you say, I don't find any changes, after 1c4b08, and 1c4bd6 are the controls of the egr, but I don't think I talk about those.

[ugoboss]

you give me the address of the 22% of couple that you see. I do not find it, I would not have attached a map to another...
also, to the addresses that you say, I don't find any changes, after 1c4b08, and 1c4bd6 are the controls of the egr, but I don't think I talk about those.

1CBD52 limiter to 22% at 1000 rpm, and immediately after 1250 six to 23.58, if you don't see them you're looking at another file and not the one posted by YOU on the forum.

[ioni]

1CBD52 limiter to 22% at 1000 rpm, and immediately after 1250 six to 23.58, if you don't see them you're looking at another file and not the one posted by YOU on the forum.

In fact...

[jhonny]

but you speak of the 22% increase?

[ioni]

but you speak of the 22% increase?

??? And what else ???

[jhonny]

Then I must have the wrong loading the map on the forum,' cause I is 9%. Even if I didn't find any map that was saved has 22% increase to 1000 rpm on the rev limiter.