Heeeellllppppp! Scodifica Partial Or Total Bosch Edc16C3 Pegeout 206Hdi

[sno74]

ok but use a sw or do you have a database for these files to be used for total...

[gezame]

Hello
It is manual, in the dump original to the car.

[sno74]

but that area, you must edit the dump you have an example for us to understand....

[gezame]

Hello
Some of the software is the same, but just reading and tamano exact.
If you read in the bdm, normally, you have to do by hand.

[zaga1]

Hello
Some of the software is the same, but just reading and tamano exact.
If you read in the bdm, normally, you have to do by hand.

Hello gezame listen to a thing you may edit the file that I posted at the beginning so total? I dissaltato the chip 95160 place in the back of the ecu and using willem programmer by selecting mode? writing I have written the e2p partial to me ? was made and now I have yet to try it.The strange thing to me ? been told
That for it to total the edc16c3 there was need of an emulator, so I have made the parziale............Now given that you're saying that really can you? make total you could make me mode? total??? I would be really grateful thanks........

[zaga1]

Sorry again I have to post the file anyway the e2p of the 95160 I modified it with software car software ? I modified it and then the scritta..............

[sno74]

but I have seen carsoft 5.2 non c'? this ecu what did you use to make the file.....

[zaga1]

but I have seen carsoft 5.2 non c'? this ecu what did you use to make the file.....

I have used car software 5.0 and anyway, there is checks good then nn I

[sno74]

I carsoft I view this page.....

carsoft.jpg

[zaga1]

I carsoft I view this page.....

carsoft.jpg

Well if you're using one of the pegeout bosch edc16c34 total 1400 69 hp should work