disabling the EGR LAND ROVER discovery 3 2.7 ecu sid

[magi1984]

but if ? a sid then after the mod write with cock okay not c'? coding injectors...

on these means do not c'? no coding injectors

[sno74]

ok thanks... the magi, but if I load the map with tita I find the drivers ? maybe a problem of my sw or ? normal I wanted to see if it was the point of the egr....

[Backgroop]

Guys by looking at the file, I found three maps that can be control or hysteresis Egr, here are the addresses 06CC3C
06AAAC 044C4C someone could confirm..

[magi1984]

all 3 addresses are wrong, for the fact of the driver ? normal that the titanium does not find it on this car
but even if he found the maps egr are out driver

[sno74]

magi I tried with ols recognizes clearly I do not have the damos but I did scroll through the map according to close I need to bring to zero the area 044DD0 to 044E4A seem to be 4 consecutive....

[ugoboss]

magi I tried with ols recognizes clearly I do not have the damos but I did scroll through the map according to close I need to bring to zero the area 044DD0 to 044E4A seem to be 4 consecutive....

I would try with these.

[magi1984]

bravo, well done...cos? for? close a single egr...that means? has 2 egr valves, so you have to try the other 4 curves similar to those
however, we're now

[sno74]

ok, the addresses are right then you have to slide the map well.......backgroop find the other then we do know the result....

[voglioimparare]

with that driver, open the file with titanium? I can't open it....thanks!

[magi1984]

read the post number 14