Pin 9 of the micro I imagine that the instructions you have not plugged in and that you have not made a mistake in the choice of the micro-to-read, with the upa my friend has not had any problems in any case, if you want I can send the ecu you only pay for the transport to the scodifica you do it for free hello let me know
Thank you so much for the availability, but I wanted to try ( and maybe succeed ) I.
The pin 9, you have to raise. I connect it as he tells me the manual of the x-prog
The exact hello and good job
from personal experience I can say that if you want to read with xprog do before I desolder
I did the test to unsolder the micro, but nothing to do. When I do Read/ write always gives me the error. If I try more? times can you read a file incorrectly
but the oscillator will you put it?Originally Written by Already
it was just what my error
for these ecu c? a swap file, use a 27c512 with this file, the balances on the ecu then feeds the ecu for 30 seconds dissaldi and re-mounting your original eprom, nothing more? the code you put only remove the lamp failure immo on the instrument panel
hello passion motors, I have seen your message and you would like to report this attachment that I added a little while ago , could you tell me if ? correct ? thanks in advance
http://www.professionalchiptuning.ne...ll=1#post83567
You speak of the files of the clock? I hadn't thought about, but I don't trovavouna memoriaa available. This file is valid for all the 16f? They told me that it does not always work.
Write permission
Quote