for info on the launch controll

[kingsnake]

after the torque limiters are a limiter diesel f(T_water) and one f(T_factor), that the map 16x16 immediately following f(speed_vehicle) ? the one to which I am referring to? I repeat that it is not ? nothing tested ? just an idea...

You know that could be? ? try...

[nasone147]

and on a jtdm edc16c39?? according to you, c'? a map that allows us to do the same thing??

I have seen a number of large point at which the ? been made!also 1.9,the cio? edc16c39!but like..I don't know,for me ? bullshit!

[angelolsp]

on the point l, I have also seen but I am not convinced ke and a real launch control because it seems that it does not load the turbine...

[giuseppe1374]

and the conversion factor?

[SandroMarciano]

for the speed? it seems to me, 0.001 for the factor precisely 0.000122 (I'm going by memory), however, you find them on the damos.

[polini]

on the fiat Abarth you cut the current to a tot rpm and map

[angelolsp]

I found a screen on how to do it edc15p... here it is if someone ke has done this can give me confirmation we would all be grateful

[angelolsp]

Then, as I said mikyrace82 here and only sketched but not configured ie is not set to the number of turns must enter and but what speed should go out... starting from this screen how to act to cconfigurarlo?

[mikyrace82]

in this screen ? configured...look better...

[dantesfx]

in this screen ? configured...look better...

I do not see the screen again, I said, just to be safe