Hi all, I have a problem on my grande punto 1.9 with gtb2260vk. I take care of myself electronics, and I can not get over the 100mm3 with the map informed. The limiters diesel I should have them arise, good or bad, all are about 6 if I remember well, some set to 100mm3 such as those in function of the speed? and the function of the pedal. My problem ? that even with those raised to 110mm3, I have all the maps scaled to 110mm3 but I don't need to inject it from the log, and I really can't understand why?. I also spoke with a few friends mappers that I did see the files but they don't explain the why? since the file ? well done. Place gold and 2 mod (in practice are the same so look at well as just what the name more? long). There horrified for advances, rail pressure,injection timing, maps out the drivers, etc, as I fit a 1.9 16v from croma 1.9 150 bhp, turbo pressure sensor 3.5 bar (of course linearized as you will see), and the nozzles in the amount of 15% (and here I have not done the mod to 'fit' but I left the timing stock and raised for? the whole map rail to have injection times pi? short, this even why? are increased, however slightly), adapting of course the timing of injection for 110mm3 on BP climbed. The map conversion nm/iq ? been adapted by adding at the BP of the nm 550nm to 110mm3, maybe not ? just perfect cos? why? I don't know which calculation to do to? there is a conversion factor of 5 nm x mm3 (as seen from the damos) should go pretty well.
We say that is not ? a map from beginners to me for? I would like your opinions and help to overcome these cursed 100mm3.
Now I have to have 240 hp and is really just a little smoke, as if he had a map-medium/soft. Turn to the 2.2/2.3 bar peak and 1.9 after the 4000, I would like to get to 2.3 peak and 2/2.1 fixed-110mm3 so you always have a fumosit? light light.
I've tried everything but I can't really go more than 100mm3, I also tried it with lambda 0.8 but nothing, it always makes 100mm3 from little more? of 2000 rpm and about 5000 rpm. Sometimes it's just a piccata fast to 109mm3 but then drops immediately to 100.
Need the help of a true expert of edc16c39.
I also tried to see a file of a forum as a stranger in that iniettavano 105mm3 on edc16c8 for? there were no limiters in the pi? that in my file and I don't know pi? really where to head banging.
To overcome 100mm3 injected on edc16c39
Quote
