Citroen C3 1.4 90hp delphi

[emilground]

Hi guys, do you know if there are problems reading/writing about the encoding injectors or another on a C3 1.4 90hp with ECU delphi ?

Thanks !

[passione motori]

Hi, which tool you have to read and write?

[explode82]

I advise you to use or the rooster, or in the kess,other tools give problems in the closing of the file, and the car could not start,for the rest there are no special precautions

[zaga1]

Hi guys, do you know if there are problems reading/writing about the encoding injectors or another on a C3 1.4 90hp with ECU delphi ?

Thanks !

I advise you to use the galletto V2 and go quiet with mpps and other stuff c'? l risk of scodifica injectors, or the kess v2 but you just need to have programmers to read and write with the contropalle diaciamo ;-)

[emilground]

I have the gallo V51 and V53. today, afternoon was I to do? reading and writing, and I hope not to have problems.
Thanks to all

[dvdtuning]

You read and written with the cock at the end?

[emilground]

Hello, I have read and written without problems

[dvdtuning]

I v48 I read it, but I don't think is write, also missing from the protocol because of the delphi gives me the 1.6 8v.
I would like to try with the magpro and then with the v53.

[explode82]

I v48 I read it, but I don't think is write, also missing from the protocol because of the delphi gives me the 1.6 8v.
I would like to try with the magpro and then with the v53.

I personally know that the v48 the ago with no problems and the protocol,even why? already done a while ago with cock ori v48 , before that I had the magpro I can tell you that without problebi

[franco75]

I read it with mpps v12, according to you ? risky to write?