Being a neophyte, and at the moment not able to understand:confused d: if you can repair a edc that the city says is not communicating with the pi? and several errors.
My doubt ? if the software of the mother house ? can clone it from another controller?
Can you help me?
That the EOC mounts on the vehicle ?
Bosch edc
Essentially, it is an engine man tga 460 euro 3
the number of the ecu ? 0281001761 2004
Practically, I have found two used but the link tells me that the parent does not update the control units that are using their hardware
and I have basically a truck stopped by a weekand
Giandomenico
The best part ? the conce told me that if my edc has the eeprom that is good, and I have put it in the edc found that ? prior to my but of the same engine it should work
At this point, being a neophyte can't he understand if hardwere specific (wing nut or other) you can get it to copy said eeprom
thanks for your interest
Giandomenico
Last edited by msport (exil77grande); 22-06-2013 at 09:56
I enclose a photo of the control unit EDC Bosch mounted....oppss removed from MAN.
the control unit man.jpg
conn.centr.man.jpg
Re-reading: - Basically I found two used but the link tells me that the parent does not update the control units that are prior to my using their hardwareOriginally Written by giaxi
and I have basically a truck stopped by a week
Giandomenico
Last edited by msport (exil77grande); 22-06-2013 at 09:58
I have not prepareto for the man I know more about the mercedes . if and like that of the old mercedes sk the ecu contains 2 eprom for the injection system and the second if to the pump with regulator advance payment, electronic . the eprom are on the socket . the already tried to open it. ps I can see the attachments or messages even enough
the two ecus used that you have found has the same number bosch?? 0281001761?? if it has the same number as bosch, you could desolder the eeprom from the original control unit of the truck, take the e2prom and risaldarla the same as that found and go... but if the codes are different, then what is ? different.....
Opening the unit, I have to say that internally ? very tidy and shows no signs of infiltration of any kind or signs of faulty components.
And in technology, micro sd, and all the components are soldered.
I was found by a collapse, or dealer of goods recycled a control unit which was mounted on the same type of engine, but with a number prior to mine, and so I think that is compatible, but the label is not readable, but having regard to the internal circuit are not able to do the exchange for the eeprom welded but not because they are not able to locate it.
Thanks for your interest
Giandomenico
Last edited by msport (exil77grande); 22-06-2013 at 09:58
you can not look at the internal differences.... if you don't read the number hw on the label, just read the file of the ecu, and it dates back to the number hw....
I enclose a photo of the control unit EDC Bosch mounted....oppss removed from MAN.
the control unit man.jpg
conn.centr.man.jpg
I think that it is a ms 6.1
From what I've seen on the web I think is a but, 6.1,
We are able to read to do a clone I have another truck is efficient and has the same Ecu. With what? Which device reads and writes to the ecu?
confirming that ? a Bosch ms 6.1 as from the research that I attach
type centr.jpg
Last edited by msport (exil77grande); 24-06-2013 at 12:36
Write permission
Quote
