Scodifica Partial Bosch ME7.3.1

[ecutano]

m not c'? the risk that I put the code immobbilizer of the other ecu?...by the way the ecu is mounted on the machine as the date of programming 00/00/0000...what does that mean? I would like to put the ecu that I took to collapse, but I should first riverginarla....I've read that you can? do...I explained how to do it? bosch me 7.3.1

Watch ? very simple ! we start from the assumption that you have the necessary to the reading of the Flash , and then read the flash in boot mode the ecu that you want to scodificare partially, after the write always in boot mode the file that you can retrieve with carsoftware , then mount the control unit on the machine and turn on the ignition , wait a few seconds after you disconnect the ecu and rewrite the flash in boot mode of reading done initially , and then mount the ecu and you have done everything correctly, the engine starts.
If you follow all the procedure you can write your own like the flash of both units .

[motorsport]

Then ecutano the procedure described by me to work??

[ecutano]

Then ecutano the procedure described by me to work??

We thank you and thanks to the forum I was able to scodificare partially.

[biancanevee]

guys I did not understand anything....in boot mode as you do, and what does that mean? carsoftware I have it but I don't understand what should I do.....and then what do I need to do all of this? I can advise the interface?

[motorsport]

guys I did not understand anything....in boot mode as you do, and what does that mean? carsoftware I have it but I don't understand what should I do.....and then what do I need to do all of this? I can advise the interface?

first you must have a serial programmer OR MPPS or galletto etc..there are pdf file you indicate some of the units to which ? need to put in boot mode to enable both reading and writing,you have to put a mass on a particular pin (GND) you need to connect on the ecu on the Pin20 for 3 seconds, doing so is unlock and you can start with the reading,when you read the file ori from the ecu loads the file in the carsoft then you only need to select if you make partial Or total "Finished"

[motorsport]

guys I did not understand anything....in boot mode as you do, and what does that mean? carsoftware I have it but I don't understand what should I do.....and then what do I need to do all of this? I can advise the interface?

Here you will find the on-line shop that is your case!!

http://www.professionalchiptuning.ne...chiptuning-obd

[motorsport]

read the post #25............

[biancanevee]

and then sorry, where are these pdf files to put in boot mode my ecu?

[ecutano]

and then sorry, where are these pdf files to put in boot mode my ecu?

Hello , the interface that you posted is good enough , the boot mode you put in the photo of the control unit with the pin-outs to put the ecu in boot mode you need to ground the pin 20 for a few seconds before entering the picture after it detached from the mass and the beginning of the reading of the flash.

[msport (exil77grande)]

and then sorry, where are these pdf files to put in boot mode my ecu?

it seems to me that you did not read my post recall and then I sent an infringement of the official, and it is already the third time that go against the rules at the next you banno permanently then I invite you to read the rules.