Soldering

[guidotacco]

where to find the trichloroethylene pure?I don't find it to 100%

I, however, after cleaning with trichloroethylene do not use anything why? first of all it annoys me to use all the ste of crap,then I prefer to buy one pond in particular that ? the treaty and has no need of dough to settle and so will not leave you even residues.........if then we talk about soldering and hot air for the mcu, I use the flux for the flash depends on the cases if I can avoid it depends on the components that are located around the flash

[maku1977]

where to find the trichloroethylene pure?I don't find it to 100%

I find it at the coop

[maku1977]

and as far as the flux...... use a liquid flux that leaves no residue..... the pasta that I felt dirty.... and important tin of good quality

[carlo abarth]

also from the hardware store!!!

where to find the trichloroethylene pure?I don't find it to 100%

[eismann]

in the specialized shops for mural painting, you should find it!

[Fedex]

To clean I use pure Acetone, it evaporates immediately, and to a good result. Use 2 Flux, a liquid and a cream. For the pond I made a stash of 40/60 and why? the new one they sell, doesn't it ? the maximum of the welds on the fly. I have 6 welders, of which the JBC that ? the top, it costs 500 euros, but the welds are guaranteed. Among the welders in the pi? of elite I have a station BGA IR, but the use for the repair of the PC, and use the flux to the cream of the AMTEC, and then I clean everything with acetone and "cotonfioc"

[filoxio]

where to find the trichloroethylene pure?I don't find it to 100%

I found it in the hardware..

do I need to replace a ecu marelli mjt the flash, that error while opening are skipped two legs.... having nothing to lose, I would like to replace it, I have a hot air station, I ordered the flash M58BW016DB80T3F , as it comes , being the first time that balance a flash of the genre, what are your tips on how to perform the weld and the products to use (flux, pasta, etc...)...
thanks

[Gia]

good luck! I have tried to replace a flash in a edc16 of a bmw, of course this. For dissaldarla, no problem, go hot air. But when risaldi,the pond passes easily from one pin to another, with the consequent risk of shorts. then a little pond

[filoxio]

good luck! I have tried to replace a flash in a edc16 of a bmw, of course this. For dissaldarla, no problem, go hot air. But when risaldi,the pond passes easily from one pin to another, with the consequent risk of shorts. then a little pond

X reduce that problem, I use the flux , even if I think x little experience , the pond tends to thicken by combining the pin, so I have to review so many times...
It would be interesting that some expert explain step pass? the procedure ..
Greetings

[guidotacco]

I found it in the hardware..

but 100%pure?