Sorry the question, but the SID 305 with galletto only v53 ? that if you can? read from the obd? For BDM obtained with V50 or V51?
thanks
Sorry the question, but the SID 305 with galletto only v53 ? that if you can? read from the obd? For BDM obtained with V50 or V51?
thanks
I have the version v48 (the penultimate), and not the law in serial mode, tried with clone china and europe, I know, but I have not got to try that with the new version V53 you can do....Originally Written by gameiruz
I have the V48 and V51, but I can not read for OBD and BDM have no proof. Version V51 to V53 I believe that it is only a matter of SW and driver ...
V48 and v51 have the same hw, while x 53 there are 1 versions, one has only the aggioramento firmware and sw is different (this has a limitation as the non-operation of the jtag ...), the other has different hw and sw is different .. and ? the best at the moment ... as soon as I install the update on my v48 and see if it goes on this car..
I tried with SO v53, but it has protection dongle...It was cos? easy ... hehehe
I don't understand if you are unable to update it!I tried with SO v53, but it has protection dongle...
I tried with SO v53, but it has protection dongle...
that sorry I did not understand....
you managed to free the protection of the version v53? have you made this car?
I have not been able to get the software ? protected by a dongle. Also tried with AES Flasher SW but without results ...
The translator ****** not ? very accurate, sorry
?
ahh ok I figured
I software v 53 I have it but not ? sufficient to run the galletto v48 ... I think I serve something else...
Clones apart.
With the cock ori I read a renault sid305 serial, in a couple of minutes has done all the work.
I noticed for? I made it just in time to finish the reading, and the machine ? way mode? energy saving! Then I didn't trust you to write it...
Does anyone know how to make them stay always active?? In the boot there? been no way to read it, do you know why?....
Write permission
Quote
