And' andataaaa !!!
I wrote the file over, and with a p? anxiety, after selecting the protocol and speed? minimum, after 8 minutes I could turn it back on
I confirm that the restart hot ? resolved
For the egr, it seems to me to note a light cleaning to low.. but I don't know if it's just placebo effect..
However, in short, the important thing ? that successful writing, now beginning to prepare for the mapping
I for the hot start port the first two corners, which in the original are at 0, 900. In this way, the drive part well and does not smoke at start-up. Software type time or carsoft increase of pi? and I noticed that starting the car chugs a lot.
And that is exactly what I did when I was a
Thanks !Originally Written by cinqueturbo
The perfectly right!!
or re-read my notes and effects with the method I described it resolves the problem of the departure,
but chugs quite a bit...
I see that you are well-prepared good, I there? took me quite a while to get there and crazie of the forum among other things....
anyway.. all thanks to the forum and to the advice of people who know
The important is to be constructive and grow..
Anyway, it is intriguing, I'm "world"
Last edited by msport (exil77grande); 17-04-2013 at 21:57
Thou hast raised to 1100, I would stay at 900, which goes ir? that's good!And that is exactly what I did when I was a
Oh, crap, you're right, I just double-checked !Thou hast raised to 1100, I would stay at 900, which goes ir? that's good!
In fact I had two "examples" and I have copied the one from 1100..
Thanks for letting me know.. so the corrected
So, I'm preparing the mapping (which will sottoporro')
Mounts to a edc16 the golf course in question?
why? I wanted to figure out where the increase in diesel fuel on the edc16c39..
Thanks!
Hello
Here is one explicazione comme labora maps de hot start.
Is not correct to talk about de 900 points or 1100 points, the value of the map are in Nm (newton-meter), and the value of the copy request in fasse starting to warm.
The map above ? the way that ? without applying any factor or offset.
The map below ? the factor and the correct offset, as you can? in some cases, see ? need to modify two curves, in other cases, the three curves, etc. depends on map original unit.
This is valid for edc16.
Yes, this is a ECD16, but ECD16U1
Ah ok, thanks!Yes, this is a ECD16, but ECD16U1
And then the addresses are not the same..
I just ordered the BMC air filter and the downpipe to eliminate the catalyst
Tomorrow I think I post the first mappetta that I will try in the weekend
Write permission
Quote