it should be the quantity of the fuel, expressed in mg ?Originally Written by DemolitionMan
IQ?? write for extended! you might think the quoziented'intelligence!
Correct me if I'm wrong, I'm a beginner, do not take me around(do not offend me, but' not ? nice when you are taken for an ignorant by a professor ...)
Then the other factor that could limit the smoke ? precisely, the map of the fumes.
look, I'm not kidding! but IQ had not intended for that! anyway you will not complicate life..! start with the main things! injection zoned , turbo, pedal rpm and torque limiter!then the other things slowly .. the car will smoke like a chimney at the beginning ? normal! then slowly you will understand why? it happens and correct your map! but if you want a course to make the chip tuning ? normal that no one you do? free...!in the forum we can only give advice and opinions.. but not courses ! ..
No quiet my problem ? on the contrary, I do not smoke at all, and I think there is some limiter diesel on the map that I know of;
I assume that the stoichiometric ratio is low, reaching the ir? air from the turbo, but always with the same diesel.
On the various tests that I cat I always empty from 900 to 1400 rpm, and can't get it to go well from 3000 rpm and up.
What do you mean by injection zoned?
map fumes
The "map smoke" ? a limiter IQ based on engine revolutions and the amount? of the incoming air.
In practice is not to inject too much when c'? a little air.
Right?
Now someone explain to me where does the term "injection, split"?
I found this term in both ECM2001 that ECM Titanium without understanding what you meant...
Edit:
IQ = Injected Quantity
it is measured in mm3
Do not blame those who use the codes ? very normal thing to use IQ, SOI, SVRPL, SVBL, etc..
Beginners should learn first the general operation and the initials are from the s?.
Something tells me that Alientech has not yet learned much, considering that on the maps as the axes of the rpm mototre and the load from 0 to 100%. But from where the hell they take that I'm loading?? Really? the axis are RPM and IQ. And if you want to do a remap as it should, you'll also need to extend the axis IQ to be able to inject more?... vabb? let it go.. sorry for the outburst..
Last edited by alex.t; 02-09-2012 at 10:59
Now you have your fireplace! at least you do not moaning +! check what I did on the pazializzato.. still missing air to the engine! and + I touched a torque limiter! check it out!good job
Last edited by demolitionMan; 19-08-2012 at 13:04
Thanks DemolitionMan, for now, I'm studying, scarichero' your change when raggiungero' 50 messages
In the meantime, I can see your map, I have prepared another.
With winols I found the addresses of the maps SOI(start of igniction) as you change these maps? Or not to touch ?
Last edited by lupak; 25-08-2012 at 22:17
There are some tutorials on the internet EDC15!
It is recommended that you take a look on them
It was cos? I started and also some files with friends and try to understand
Write permission
Quote