Fiat Bravo Mjet 150hp 2007

[mariodarkblue]

hi guys...I am attaching the file ori and the first mod of the bravo mjet 150hp that I took about ten days.
First of all, I made a first map only with the egr closed (to the contrary. if someone me the check)...now the car ? in the workshop to make megatagliando...distribution, various filters, cleaning manifolds, intake, and I removed the swirl, which needless to say had about half a cm of sludge...not to mention the egr...now you just tapped.
On edc15 c'? chance? do switch off the dell egr..su edc16 I read that you can't?...confirmed?
You can? make the switch off of the swirl or should I keep the starter motor cmq attacked?

[cawadany]

The EGR ? excluded properly. For the swirl I'm sorry but I can not help since I do not have the permissions to access the guide on the forum and do not know how to do this change.

[magi1984]

you can? do but the starter must remain still attached, otherwise you have to disconnect, see the DTC is stored, and then delete the dtc from the map

[Alfa159 q4]

The exact leaves the starter motor of the swirl attached to and acting on the curves that regulate the opening you will not have problems.
Some while removing the swirl, do not give out any error on the body..then not c'? even the need to intervene from the ecu.

[mariodarkblue]

Guys, thanks for the chiariemnto about the swirl...now, I looked at the various maps in the network, and the curves of the egr are 4 to bring to 0...I see two on my...c'? any particular reason?
*magi1984 I would explain better?

[cawadany]

I have given a look at the guides that are on-line, and for the EDC16C39 are 2 bends of the lead to 0. And you did.

[mariodarkblue]

Ah, ok...it is perfect...can you tell me something about the game?

[Alfa159 q4]

Guys, thanks for the chiariemnto about the swirl...now, I looked at the various maps in the network, and the curves of the egr are 4 to bring to 0...I see two on my...c'? any particular reason?
*magi1984 I would explain better?

Watch, some are 2..su the other 4..and on some there are 6 controls to be reset to the egr. Depends on the file, send me the ori in pm and I will tell you soon

[mariodarkblue]

Ah here is revealed...and then in parit? ecu these edc16 can have 2 4 or 6 hysteresis curves...too bad you can't do the switch off as on edc15...*alfa159, you around the map n pm

[Alfa159 q4]

I sent you my ****...
I don't understand why? you say switch off on edc15..su these closes, bringing the maximum value in the map with the egr.
The Switch-off is on marelli 1.3 mjet