reading ecu Volvo XC 90 Edc 15C-11

[sno74]

info to read this ecu from what I have seen from the various protocols on the serial line is not read I wanted to know if anyone has read it yet without unsolder the 29f400 I saw on a post that they read with galletto in the boot....

[giarras]

info to read this ecu from what I have seen from the various protocols on the serial line is not read I wanted to know if anyone has read it yet without unsolder the 29f400 I saw on a post that they read with galletto in the boot....

I believe that you need to disaldare the 29f400 cmq better informed I do? I, too. with edc16cp31 can you?
gallettov2:
XC90 2.5l Tdi Bosch EDC 16CP31 R/W Yes Flasher

[sno74]

this ? what I read in the post "experiences on the volvo xc90 read and writing in mode boot WITHOUT DESOLDERING ANYTHING volvo xc90 edc15c11 by selecting from the voices of the gallo volvo v70 edc15c3 to pin 24 of the eprom I put the mass" I saved the txt reminder.... But you say that can? be a possible thing...... or better not to risk....

[msport (exil77grande)]

this ? what I read in the post "experiences on the volvo xc90 read and writing in mode boot WITHOUT DESOLDERING ANYTHING volvo xc90 edc15c11 by selecting from the voices of the gallo volvo v70 edc15c3 to pin 24 of the eprom I put the mass" I saved the txt reminder.... But you say that can? be a possible thing...... or better not to risk....

I honestly do not take risks,better to unsolder that electrocute the ecu.

[giarras]

this ? what I read in the post "experiences on the volvo xc90 read and writing in mode boot WITHOUT DESOLDERING ANYTHING volvo xc90 edc15c11 by selecting from the voices of the gallo volvo v70 edc15c3 to pin 24 of the eprom I put the mass" I saved the txt reminder.... But you say that can? be a possible thing...... or better not to risk....

and I am not risking disalda have also had confirmation from the other party, if I'm not mistaken, right?

[mavaila1972]

this ? what I read in the post "experiences on the volvo xc90 read and writing in mode boot WITHOUT DESOLDERING ANYTHING volvo xc90 edc15c11 by selecting from the voices of the gallo volvo v70 edc15c3 to pin 24 of the eprom I put the mass" I saved the txt reminder.... But you say that can? be a possible thing...... or better not to risk....

read in boot with kess v2

[jolidj]

well I read and written into the boot without problems . what you have marked, and stuff of my own, and I can assure you that funzia.io I have the rooster gold and that I very badly that you have to go to unsolder after.

[sno74]

I wanted to read it but with gallo 1260 version clone say... and you say that c'? I make it in the list the car you selected c'? for? should I try it or better to leave as my not ? the original.....

[msport (exil77grande)]

I wanted to read it but with gallo 1260 version clone say... and you say that c'? I make it in the list the car you selected c'? for? should I try it or better to leave as my not ? the original.....

well try if the law does not cost you anything then analyze the file if it is ok, and in case you can attempt the writing.

[sno74]

exact does not harm to try.....