I don't know why I can't enter it!!
I don't know why I can't enter it!!
look at that you ? send pappy ultrafast time-and on Sunday evening http://www.professionalchiptuning.ne...5181#post35181
try to write with the 2 in serial see if it starts again as the cock on these ecu is reading the entire
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
hello, I do not have this cable:at 2, where I can find it?thanks..
I'm sorry I made a mistake I meant to write the galletto 2 to avoid to open the ecu otherwise open, and go to bdmOriginally Written by giulianoA3
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
possibly the galletto 2 where can I find it?thanks..here on the forum you want to sell?HELLO
hello, nothing to do, the ecu does not want to know..bdm says error connection ecu!!any suggestions?hello thanks.
just last week I due to resume in the bdm. Which bdm uses ? if you use the bdm100 software 1255, I can say that I had problems too, so much so that I've had to resort to the software of the dimsport ( what ? also pi? old) since? only with this last scripture ? come to a good end. with the 1255 told me that it was necessary for the complete file, even though I had a backup of the same car.
However, check carefully to see that there is no contact between the schedule-spring, and the plots why? just a little movement out of the office not to communicate.
yes, I also confirm that I have had problems with the 1255 with this ecu, did everything right with cock 2!
I'm giving a hand to his friend julian,
these are the errors that I get from both bdm 100, with galletto2:
this ? the error that the bdm 100:
CMD ? Technologies srl - MPCProg
Ver. 3.1.0.1255 Dongle ID: 192 Date: 29/03/2013 13.57.47
Firmware Revision V.01 SN: 0258
Interface Communication Error
+12vdc power error or Communication error
as if that was not fed to the ecu.
I tried to feed it, even from the comb,but nothing
galletto2:
READING DATA....
start reading the data......ERROR MICRO NOT SUPPORTED
the operation was canceled
when I bought the bdm100 gave me that error and didn't read any ecu. I have changed the bdm and now it works, but in this case, you have a striker with another bdm then.... you just have to make sure that one of the functions cock
Write permission
Quote