Mag pro error step n: 37 EDC16

[giarras]

Ok, you are in effect part and it works correctly, just that I can not more scriverala and read it via serial,
? a mystery.
First try to resolve via serial if not as soon as I get the programmer eprom and bdm I try it on the counter.

Mag pro I just says "Ecu locked", but with that error code we don't understand the problem?
"ERROR STEP n: 37"

sure that I have used ecusafe? and now does not allow you to read it?

[sportknight]

I also thought about the block ecusafe....

anyway, try to rewrite directly to the original

[vic64it]

now touch yourself, or try to read the tour attaccandoti to comb or aspects of the bdm

[hackgen]

I also thought about the block ecusafe....

anyway, try to rewrite directly to the original

I can't write the original on magpro you enable only the " data " button once and hold read some information of the ecu, and then exits l error,
the write button is not ? enabled. Thanks

C'? any way to send the ecu in recovery mode?

thanks

[hackgen]

sure that I have used ecusafe? and now does not allow you to read it?

I have not used ecusafe, not the law he writes the map, with mpps with mag !!

[sportknight]

I know that the last time ? been remapped to something ? gone wrong,now waiting for the bdm why? you may also try to force the writing in the boot etc... but if it crashes then they are dicks!!
the boot should also solve ? cmq a risk

[pinotec]

It gives me error already? in the process of reading, as if there was something that stopped me ? for? had a doubt, this defect if I'm not mistaken ? out of it from when I changed the key, I would not be the encoding of the key tonight I try with the spare key.
The battery I scored 12.6

Other tests?

according to me the problem and due to the fact that you changed the key.
evidence that you do and unsolder the 95xxx and try to get her to tour with eep detached
or make a scod total on the eep and always try to counter it

I know there is no boot on edc16

[hackgen]

How do I do it in the boot?

Thanks

I know that the last time ? been remapped to something ? gone wrong,now waiting for the bdm why? you may also try to force the writing in the boot etc... but if it crashes then they are dicks!!
the boot should also solve ? cmq a risk

[hackgen]

according to me the problem and due to the fact that you changed the key.
evidence that you do and unsolder the 95xxx and try to get her to tour with eep detached
or make a scod total on the eep and always try to counter it

I know there is no boot on edc16

Look, I don't remember if after changing the key I flashed or not,
I also tried with the old key, but nothing.

[hackgen]

To put it in bootmode you have to make a bridge between two pins?

So you have to disassemble?

I wanted to avoid to take it apart, if I have to disassemble aspect of the bdm and do with that.

Can that not c'? no procedure via serial?