I also tried with MPPS and gives me an access error to the control unit, while the Mag is able to read some of the information type chassis type unit serial etc,
mpps nothing just fails to access. Other suggestions?
I also tried with MPPS and gives me an access error to the control unit, while the Mag is able to read some of the information type chassis type unit serial etc,
mpps nothing just fails to access. Other suggestions?
but it had been already? remapped?
You, ? was remapped several times, always with success.
Originally Written by sportknight
also try to change the pc, which at times are in conflict, the usb driver
Tried to be thorough, but the drivers are ok.
The last time ? been programmed ? been done with mpps, may have miscalculated the checksum and that now don't make me log in?
If you like I can fix, at the moment I can not intervene in the bdm I get all the needed among a fortnight.
Thanks
impossible, a cecksum wrong with the car even started.
try to disassemble the unit and to read it in the tour attaccandoti on the comb
Ok, you are in effect part and it works correctly, just that I can not more scriverala and read it via serial,
? a mystery.
First try to resolve via serial if not as soon as I get the programmer eprom and bdm I try it on the counter.
Mag pro I just says "Ecu locked", but with that error code we don't understand the problem?
"ERROR STEP n: 37"
I don't even know at what point it crashes, I also happened to me a similar thing and I have had to do it.
Write permission
Quote