I see a doodle and just at that address. you nn you touched no torque limiter certain that you will limit the machine.
If you have the opportunity to try it try it so , you will serve as an experience.
I see a doodle and just at that address. you nn you touched no torque limiter certain that you will limit the machine.
If you have the opportunity to try it try it so , you will serve as an experience.
I put the screen with the changes made... so see what I've done... tell me what do you think?Originally Written by jolidj
anyway tomorrow I try this map.
1d358e_OK.jpg
here it is. at the beginning of the map you see that strange change??? mica and normal.give it a try and go to know.
in fact, you're right... first the eye seemed to be a change that I have done through the driver.. but looking good ? one thing out of the driver then I do not know from where it had jumped out... mahh.*****o I removed it.. Now I try tomorrow and then we will see....
I tested the camera! not bad at all! pull enough from the 1500-1600 rpm...
the thing to improve ? the recovery of the first and second gear (this car suffers from is the hole of power at low revs to the first 2 gears).
very good. if you like to you we are happy all. good fun .
hmmmm... must make improvements....
hello!
I tried the machine for 3-4 days! I still have the problem of the loss of torque/power at low rpms... especially in second gear between 1100-1300 rpm...
I am in the driver titanium I have maps torque for each gear... I can act from them? but I always say that you touch the things from 1500 rpm up...
what do I do?
normally it starts from them not too easy on the clutch. then each one ? ****** to do as he sees fit on his car
[COLOR="#0000FF"][CENTER][B]In life you never stop learning![/B][/CENTER][/COLOR]
[CENTER][COLOR="#FF0000"][B]I do Not answer to private messages with requests for help! If you need a hand, ASK ON the FORUM!!![/B][/COLOR][/CENTER]
You can raise the lim of gear, especially the 1 and 2,I have not looked at the map, but they are usually the lowest of the other,tries to give increases in the rpm low and see,again I have not seen the map but they don't do a maximum of a bit of smokehello!
I tried the machine for 3-4 days! I still have the problem of the loss of torque/power at low rpms... especially in second gear between 1100-1300 rpm...
I am in the driver titanium I have maps torque for each gear... I can act from them? but I always say that you touch the things from 1500 rpm up...
what do I do?
Unshared knowledge remains an end in itself.
Write permission
Quote