mpps 12 500 abarth

[emilground]

for charity? we believe, for? according to me it takes care of everything. For example, if while writing you accidentally touch the lever of the headlights you can create problems, why? those about 8 amps in absorption do to lower the voltage even slightly, or if you also lower the glass.. As I write, I remove all and leave the pc resting on the seat without even touching it until the end of the writing, and when I can ( if I'm not outside), I connect the power supply in parallel to the battery. Another thing, according to me, important ? do not leave objects in the electronic type phones that are close to the programmer, this is why? interference may occur.

[legendaryslave]

I know that mpps on me7.9.10 has planted a few days ago just a friend ? the success that has called me and I advised her to put it in the boot, and a problem of interface that goes not so much agree

[emilground]

? almost a terror, the write lock and also when I write fingers crossed!
I pushed the writing to a bmw 118d when all had told me not to try, even in serial with clone V5 and ? everything went ok. Perhaps what I have ? a clone well done

[ecuboost]

surely it will be? a good clone qst point

[lancia delta evo]

Guys the 7.9.10 the you can lock all the times that you want to pi after boot with two resistors of 100 ohms the write back with a gold ulsiasi downloaded over the network I have written with any interface, and I have blocked several times because of the cks but always shoot are simple ecu bosch (eat everything).

[bart]

Guys the 7.9.10 the you can lock all the times that you want to pi after boot with two resistors of 100 ohms the write back with a gold ulsiasi downloaded over the network I have written with any interface, and I have blocked several times because of the cks but always shoot are simple ecu bosch (eat everything).

Hello lancia delta evo, could you please explain the specific steps to put them in the boot?
Thanks!

[FidodidoTuning]

with this procedure

BOSCH_FIAT_ALFA_ME7.9.10_ST10F275.jpg

[bart]

Thanks 1000 FidodidoTuning: very nice!

[sno74]

with this procedure

BOSCH_FIAT_ALFA_ME7.9.10_ST10F275.jpg

clearly with gallo v2

[albertorapper]

I have mpps v12 and when I go to read the me7.9.10 (I have a alfa mito ) does not give me the command that is available, just write!