values increase with ecm titanium

[succdfrutt]

good day guys, I am trying to change the map of my car "Mazda 2"
but that values are recommended to be able to edit a map?

[magi1984]

depends on the maps, you can usually give a 15 or 20 percent in the maps of the accelerator pedal, 25 in the torque limiters, 5 in the rail, 7 in the turbo and at the time of injection, this is for bosch ecus. Cos? the discourse ? however, very generic. When I did the course in alien they told me incrementar from 2 to 6 in all of the maps and a little more? in the limiters, that way the damage will not do but the increase of horses ? your minimum.

However, attach your original file so we may be able to give us a look

[msport (exil77grande)]

honestly just use the search, and there are several similar discussions already treated with directions also on the increases in the standard to be applied so I would say to look good on the forum.

[fabio1207]

honestly just use the search, and there are several similar discussions already treated with directions also on the increases in the standard to be applied so I would say to look good on the forum.

Sorry I tried but not able to find definitely do not do it well you can help me find something ? Thanks

[succdfrutt]

continues here... http://www.professionalchiptuning.ne...zda-2-1-4-tdci

[munro]

I would just like to point out that not all the maps to increase a given value leads to an increase of that value...
for example let's take, for examination, maps "smoke" where the value of the descriptor, or z-axis is expressed in "lambda" to increase the diesel fuel in this map from the lambda factor 1,that is to say the optimum, the manufacturer is established in order to increase the diesel you have to lower the lambda factor...then 0.9 lambda corresponds to the most diesel
conversely, a high value of 1 as 1,2 corresponds to less diesel or carburantein genre inject to comply with that title lambda...

[pitty]

I would just like to point out that not all the maps to increase a given value leads to an increase of that value...
for example let's take, for examination, maps "smoke" where the value of the descriptor, or z-axis is expressed in "lambda" to increase the diesel fuel in this map from the lambda factor 1,that is to say the optimum, the manufacturer is established in order to increase the diesel you have to lower the lambda factor...then 0.9 lambda corresponds to the most diesel
conversely, a high value of 1 as 1,2 corresponds to less diesel or carburantein genre inject to comply with that title lambda...

this speech in practice is not true for the bosch, right? should be valid for the multijet engines? I don't understand granch?... please....

[nuovaecu]

and as you make modifications always test the car and you go realizing what to go by tapping experience

[succdfrutt]

I'm afraid to break the car ecm titanium I do not read well the values of the mica unit siemens...

[Team elettronica]

Fear? go slowly and increasing, and by trying you will notice if you make mistakes or not

somewhere you must start nn you think?