Mpps reading golf 2.0 tdi 140 cv

[msport (exil77grande)]

sorry msport with mpps the passat you can read and write?

mpps v12 reads/writes and corrects the ck automatic siemens ppd

[legendaryslave]

mpps v12 reads/writes and corrects the ck automatic siemens ppd

even if the blocchicchia a little bit, but if you insist resumes

[thekid]

even if the blocchicchia a little bit, but if you insist resumes

what would it mean??? not ? as secure as a letter\writing because I can't afford to take the risk of locking the ecu.

[legendaryslave]

the blocks 90 percent, however, raises the writing and the ripii the block ? almost safe with this programmer on this ecu

[msport (exil77grande)]

the blocks 90 percent, however, raises the writing and the ripii the block ? almost safe with this programmer on this ecu

I have had some customer that has read and written without any problems,completely unique that they have made a mess were those with earlier versions of mpps don't understand that not corregeva the ck in automatic, and then the car would not start but then rewriting the ori started.

[legendaryslave]

I, instead, more of a friend has tried to write it with the mpps, and you ? locked writing, then try again a couple of times, and you can write however the resume preticamente always
here the speech

[sno74]

And the problem is that if you say it hangs, do you take a nice nod to? if you say that at the end of the resume much better but some people say to avoid the block select the speed? slow from writing options puts us more? time but not responding.......

[panterargento]

strange, I did a golf 5 140 hp with both cock with mpps and without problems...

I have to make myself an equal, that the protocol you used?
I have these available with mpps v12:

2.0 TDI BOSCH EDC16U1 K-LINE
2.0 TDI BOSCH EDC16U31 K-LINE/CAN
2.0 TDI PD BOSCH EDC16U34 K-LINE/CAN
2.0 TDI SIEMENS PPD1.X K-LINE/CAN
2.0 TDI BOSCH EDC17CP14 K-LINE/CAN

I assume that the one that reads...writes.

[sno74]

sorry, but the protocols are not to be uploaded in case you have to put the right one otherwise you plant the machine connects and make id then post the code bosch ecu or plug in a diagnostic tool and see what port the machine.....

[panterargento]

sorry, but the protocols are not to be uploaded in case you have to put the right one otherwise you plant the machine connects and make id then post the code bosch ecu or plug in a diagnostic tool and see what port the machine.....

I have not told you upload them to the case, but the fact that if you choose a protocol that is wrong I think not face reading...and I think that what you can read, then they can write.
However, in order not to make mistakes between an hour to do the ID and the place.
Thanks sno74